Recent content by Stewey

Try these guys - decent prices and quick shipping. Good luck. https://www.jthomasparts.com/parts-by-category/blades/blade-adapters

KenC is on the right trac. Contact a certified arborist for an evaluation and recommendation for your situation. There are standards under ANSI 300 that should provide enough information for you to make an educated decision. I can tell you that I can currently involved in a project where we are...

Did you check the spark arrester? Sometimes they load-up and cause issues similar to what you are describing.

I’m in - actually could have put this to use last week! Thanks for the thoughtful gesture.

I really appreciate all of the responses, once I get the tool in my hands I will confirm the thread/pitch. I’m just concerned the this smaller hammer won’t accommodate the standard otc attachments.

I did a fair amount looking on the web with no luck and hoping that someone may have good solution. The adapter would need to fit Snap On’s small slide hammer (CB93b?). The problem is I believe the threads for that model are 3/8” and all I have been able to find are fittings for the larger 5/8”...

I disagree... Check out the Utilizer 2.0 offered by Spectrum Energetics Machine Shop. $250.00 worth of titanium goodness.:shocking: