Recent content by toddjg

that is what the shut off valve shuts off at needed to test . but safety valve would not let me.

oh yeah don't need the tank to blow up.

for a sec. i was thinking what the hell and then saw what the problem was. I can't expect much from hf. I will just wait see how long it takes them to send it out.

I just hooked up my 60 gallon 5 hp hf air compressor. It started up fine oil fine its running so let me see if it shuts off when it hits the 165 psi mark as it says in manual. watching gauge here comes 150 psi and there goes the safty valve compressor still running. take a look at safety valve...

the 220 line that is there now is wired into an outlet the 2 blacks goto the power the white goes to the ground the green is ayyached to the outlet box its really just been pulled through the box not screwed in. I was going to wire the 2 blacks power white for ground and attach green to frame...

I have a 5 hp hf air compressor. I have a 220 line in garage that has 4 wires 2 black 1 white 1 green. Does this sound right I have been told it should be 1 red 1 black and 1 green . does this sound right?

I was going to use it for car painting all air tools for working on car grinders cut off wheel. da sander.

Was looking to by a compressor anyone have any info on the stuff sears offers. I was looking to use sears card i was thinking of getting a campbell hauser maybe the 60 gal 5 hp. any info would help.

do they make old drill bushings?

I have an old milwalkie 1/2 inch drive drill its the old all silver case no plastic. I was using it and it just stopped I stopped using it let it cool it worked then it stopped again does not work at all now. Anyone know what could be the problem how to fix or does anyone know where i could get...

its an older model with a jacobs chuck on in it says tapered on the chuck. there is no screw in the middle that is for screw on chucks .

Anyone know the best way to remove a tapered chuck 3/8 its made by jacobs their instructions say you have to use a wedge that they sell. Anyone have experience with this?

where is it made?

should i get screw machine or jobber. There are for use around house and in garagr working on harleys and car and pick up trucks. Also working on old carbs and vintage car and motorcycle parts.

how about enco?