Recent content by tody009

ok guys 19mm is a 3/4 almost on the money exactly :willy_nil 17, 19, 21, 22 on a daily basis.

I have both a 2135i and an m18 fuel 1/2. i work in a shop and use the air 99% of the time. its a lot lighter, freewheels (the Milwaukee does not), and maybe a little quieter. The main reason is when doing tire rotations and the car is racked, you can unbolt the wheel, and let the air gun down to...

well i ordered the stahlwille wrench set and it was 81 dollars.. lets see what shows up lol

they look like every other jack stand.. why would usa made leave a bad taste in your mouth??????

there is something wrong with your air supply, or your air supply.. possibly even your air supply. a 2235timax will take off anything you point it at.

have done the dime trick before.. I'm thinking I may upgrade and get the snap on kit that was mentioned above.. I think it has a penny, nickel and quarter in it too.. used they are about 95 bucks on ebay :bounce::bounce::bounce:

you know its a good project when the sawzall comes out on a transmission job... :lol_hitti:beer:

got some tools.. first is a box cover that kinda counts as a tool right? super happy with it. quality is top notch and it fits like a glove! next is a snap on drawer trim installation tool for my kr1000 that I refinished. I put the yellow tape on to protect the face but it is well made...

saw the email this morning and ordered it.. i guess if the pliers are meh i can give them as a gift or something. has anybody actually used them? i havent found any solid evidence of use except for the botox comments on the jaws lol

Steel wool or 2400 grit sand paper has always worked for me.. The secret is go slow so you don't over do it..

Got this from amazon today.. Good to see still made in the USA :beer: also Riko the retardweiler wanted to see what tool I got :lol_hitti

because I ride a ktm and ive always loved the blue and orange idea..

thanks for the feedback guys! I'm pretty happy with the way it turned out! the blue trim idea is tempting.. maybe I can have the old trim refinished :confused::wtf::dunno:

if you are lucky enough at the bottom of this picture there is a conversion drawer snap on sold to replace the top two drawers. don't know if ive ever seen one but its possible.. just reread your post and looks like you have a diff box... but yeah!

I was hoping there was a chance to put a deep drawer up top, but there is no easy way. in this pic you can see there are no extra "holes or slots" for the slides. I think you could put a deep drawer up top but in order to put the two shallow drawers back to where the deep drawer came from you...