Recent content by TubingJon

How did the lift end up? I am looking at one as well but curious on the height as that it shows a range on the spec sheet.

Looking at the PVC panels, any input?

Looking for interior liner panels in SE Michigan, where does everyone go? Thanks.

I currently run 5000 square feet of radiant heat in my house including my garage with a Knight boiler, never a hiccup in 9 years. It does my domestic also but the shop only has one full bath and no need to maintain DHW all the time, that is why the combi boilers are so appealing. I just want to...

What would you recommend? This is in a 40x60 shop that I cannot afford for the heat to go down in and freeze the floor. My decision is not driven by cost either, I would rather spend up front than down the road. Thanks.

Looking at a Navien NCB240E for domestic and in floor service, anybody have experience with one good or bad. Thanks.

Looking at putting a 200 amp service in my shop. I have a 325 amp meter socket with a double lug set up at the house so looking to pull from there, the distance is 400 feet to shop. What size conduit and wire should I be using and is a 200 amp service really necessary, using the standard air...

They make a copper stub out for pex, put it through a hold rite bracket and you are done. Then on finish you cut the 1/2" copper and put a standard 1/2 x 3/8 compression angle stop on it. You could possibly still do this if you have a steel interior finish.