Recent content by unvago

I have an older clock with a two wire transformer and starter. It also has a round flourescent light. How does one wire to and from the transformer?

Thanks

I have a Quincy compressor with a HP of SPL and 15 amps. Not sure what the HP is but thinking 3. Will the following work as a disconnect? SQUARE D BY SCHNEIDER ELECTRIC QO200TRNM 60A Non Fuse Disconect

This has been covered numerous times but I will try to explain what I need. I have 4 exterior garage lights and would like to add one remote exterior motion sensor to control all four lights.I presently have a control that installs in the switch and a remote battery sensor that is mounted...

Perfect, thanks

I also have 4 outside garage lights on a single switch. I would like to install an outside motion sensor for the lights to come on at night. Would like a link or name of what to purchase.

I have a Danmar and it has performed well for the past 4 years.

Where are the best priced aluminum ramps for a Danmar 4 post lift?

I have some Gas pump panels available. Take a look.

I have a Liftmaster laser guide that connects to your door sensors, $20.00 plus shipping. Works great.

I got these from Saferacks. They are 3' wide and 8' long. Easy to install.

The run through the attic will not be in conduit, only the portion going underground from the house to the new garage. Roughly, what is the difference in price between #6 and #2 aluminum?

MRB, My installation will include pulling the wires through the house attic from the main panel, down a wall, then underground to the new garage. Thanks for the infor on the number of wires.

I did not think about Cat5, but I will plan on it.

Thanks for all the input, I was sure that #6 was too small. The cost for 100' of copper is way too much, I will go with Aluminum