Recent content by Vegas Painter

  1. V

    Snap on- Paper or Digital Catalog?

    The snap on website is one of the most un user friendly out there today. I have found the the only way I can find what I want is to find it in the paper catalog and input the numbers in the website. Sent from fabulous Las Vegas
  2. V

    vinyl fascia?

    Vinyl facia material is really wavy. It is very hard to make look nice. I recommend using aluminum facia. If you have to use vinyl the only place you can nail is up through the bottom. Slide it up under the drip edge at the top. It will hold it there. Sent from fabulous Las Vegas
  3. V

    Finish nailers (15g) - Hitachi vs Senco?

    I've had a couple of each over the years. Performance wise they were the same but I like the look and feel of hitachi products better. Sent from fabulous Las Vegas
  4. V

    Moen Cartridge troubles

    I've had bad ones out of the package. If its a knock of one they are notorious for being junk. I would try another one. Grease it good. It should be fine. Sent from my iPhone using Tapatalk
  5. V

    Cen-Tech Code Scanner from HF, Any Good...?

    I have one. It works great on my Tacoma and Caravan. For some reason there are a few vehicles that it won't link up to. It won't work on my neighbors caddy. I have also read it not linking up to other vehicles. Sent from my iPhone using Tapatalk
  6. V

    Best Circular Saw under $150

    I always recommend Makita for a general circular saw. I've had 2 for 25 years and they have been great. Sent from my iPhone using Tapatalk
  7. V

    Porter Cable 18V NiCD service?

    I bought 2 on amazon a couple months ago for $35 a piece. I had one do the same thing. Sent from my iPhone using Tapatalk
  8. V

    Problem with a deadbolt

    I've installed a lot of deadbolts over the years. I used to have the same problem from time to time. What problem happened is one of the machine screw were cross threaded and when tight it is just a little off. I have loosed the screws a bit and put lock tight on it. If that doesn't work buy a...
  9. V

    Snap on bits

    Which snap on #2 Phillips bit do you guys recommend for a impact driver. I've broken to many lately and need to change. Thanks Sent from my iPhone using Tapatalk
  10. V

    Siding question

    I installed siding in the Midwest for 15 years. Never put any directly over studs. Lots of old houses had it like that. I think it could buckle or warp easier. Just my opinion. Sent from my iPhone using Tapatalk
  11. V

    Best sprayer for latex paint?

    Titian 250 from Home Depot will do you fine. Sent from my iPhone using Tapatalk
  12. V

    Snap on Screwdrivers

    I love the soft handles. Will probably never use a hard handle again. Sent from my iPhone using Tapatalk
  13. V

    Lowes picnic table

    I have made a few picnic tables out of cedar. It is cheaper to buy than build. Sent from my iPhone using Tapatalk
  14. V

    What tools does Craftsman still make in the USA?

    The new raised panels are all china now. I was in Harbor Freight the other day and they now have raised panel wrenches now. They look the same. Sent from my iPhone using Tapatalk
  15. V

    Picked up a USA Crescent 8" adjustable today !

    I agree about the sloppy jaws. I threw away an 8" for that very reason. Terrible. Sent from my iPhone using Tapatalk
See more
Top Bottom