Recent content by vroach1951

  1. V

    Best grinder to remove TLPPC

    500sf. About 6-7 hours with the edco and 3-4 by hand. I spent a while getting the wedges right. The ones my rental company included were made from plywood. They lasted about a minute. Expect about 50-100 sf/hour if your floor is hard
  2. V

    Best grinder to remove TLPPC

    Good luck. After the edco machine I used the diamabush hand tool on my makita buffer. Kept it under 2500 so the shop vac would keep up and so I didn't gouge up the floor. Have a few fine shop vac filters on hand and change them frequently. It helps to see what your doing.
  3. V

    Best grinder to remove TLPPC

    Thanks for the help, both of you. Doing the floor was easier than I expected. I was nervous about the short pot life of the epoxy, but that wasn't an issue, ended up having to wait a bit between the rolling and flake. Luckily my cat tested the plastic at my garage door when I was...
  4. V

    Looking for a bolt.. probably a long shot

    Licence plate hardware from a motorcycle store, motorcycle superstore, Dennis Kirk. Ect
  5. V

    Wheel bearing/hub assemblies - 1a auto, timken, or Napa

    I can't comment on the a1 brand, but I used the auto zone brand on the passenger side of my ranger, It had movement in the bearing before 2500 miles. I replaced both sides 20k ago and all was well at my last tire rotation.
  6. V

    Best grinder to remove TLPPC

    Epoxy, full broadcast. I will need to have plenty of hardware on hand whenever I work on anything
  7. V

    Best grinder to remove TLPPC

    Nope, not Australia, mid Atlantic region. Don't know how to add my location either.
  8. V

    Best grinder to remove TLPPC

    Why do my photos get flipped upside down? Sent from my SM-G935V using Tapatalk
  9. V

    Best grinder to remove TLPPC

    The tlppc is gone, I chose the other extreme this time around Sent from my SM-G935V using Tapatalk
  10. V

    Best grinder to remove TLPPC

    My other garage has bare floors, but after 30 years they are looking bad. I thought I'd try a coating on the new floor. Sent from my SM-G935V using Tapatalk
  11. V

    Best grinder to remove TLPPC

    I started with the edco. Did good other than the damn wedges. On to the 4.5 diamabrush. Need to hunt down the hand tools to finish. Might try my right angle die grinder too. Sent from my SM-G935V using Tapatalk
  12. V

    Best grinder to remove TLPPC

    I'm almost done grinding and I would like to know how to remove the last inch along the walls Sent from my SM-G935V using Tapatalk
  13. V

    Best grinder to remove TLPPC

    My letter said something about an exclusion in the coverage. I plan on picking up the grinder this week, been waiting on some more favorable weather before getting started Sent from my SM-G935V using Tapatalk
  14. V

    Got my Armorpoxy/ArmorClad floor down this weekend!

    What were your weather conditions and about how long was your working time with the epoxy? Sent from my SM-G935V using Tapatalk
  15. V

    gas tank sealer

    I used the Eastwood kit about 5 years ago on a 60 year old tank. No complaints so far except for the workout I got prepping it Sent from my SM-G935V using Tapatalk
See more
Top Bottom