Recent content by vrocket

Can't you adjust the wildfire lift by tightening the cables to make sure it's level. Seems much more secure since 4 sided post

I have a sub panel going to my metal building which I want to put a lift in . I have attached a picture of the wiring in panel. It looks like 220 volt coming so all I need is a dual breaker 20 amp for the outlet and run wires to the plug location.

I have a 30 x 30 shop in which I want to put something on the concrete floor. I use this area for general shop work and park classics on. I have epoxy floors in previous floors and find it somewhat expensive. Have tried tiles and found several issues. 1) noisy to walk on 2) Static electricity 3)...

What is cost per ft?

Re: RACEDECK[emoji2400] Holiday Deals Did you wax your tiles they look really glossy

What does the race deck cost per ft/

I have a 30x30 shop with race deck on floor with a 4 post lift with wheels and have no problems.

I used a table saw worked fine

Just building a new 30x30 x12 metal building. Trying to find out what the price of Race Deck flooring is in Phoenix az.

I built a 30x30 shop with 12 ft ceilings in colorado and it gets cold here. It is well insulated and tried using a electric heater 220 volt last year was just to costly. I thus switched to a pellet stove. I do have race deck floor which helps keep floor warmer.

I have the same (DAYTONA)and it works ok, just need to go to the bank to pay the electric bill if you want to use it. I am in the process of putting in a Pellet stove in my 30x30 shop with 12 ft ceilings. I think it is the only way to keep it around 55 all the time. My shop is well insulated...

Its all China ****

I did the same thing and havent fixed it. It only makes me mad when I clean the floor and wax it.

I am so sorry for your loss and ours hearing form him on the forum. God Bless you and your family

I installed bendpak HD-9 in my 3 car garage and it worked ok. Was parking Corvette on top with bikes underneath. Chevy truck next to that and wifes acure too. The only problem i had was the ceiling height could not max out. I have casters and they allow me to move the lift exactly where i wanted...