Recent content by Wheelgun1

I looked at a weaver a guy had for sale in his home garage, 5,000 lb unit. Well built, similar to a mohawk in construction, had a floor plate for a chain, single ram style. Probably from the mid eighties I'm guessing. Had a big mounting area on the posts as well which I liked. Had it been rated...

Hydro Seal, if you can find it anywhere anymore, is /was hands down the best stuff ever. When they stopped making that I went to spray HogWash. Then they stopped making that. It was a couple hours or so in the hydro seal. With the hog wash, I just sprayed let it set for a few then a healthy...

You have a single overhead line correct? The way to bleed it to my understanding is you need to find a fitting that will thread into your slave side rams bleeder screw, (which should be 3/4 fine threads) preferably a barbed style that you can connect a long piece of clear tubing to, which you...

I know I'll probably get flamed for this but yes, eliminate some of the big stuff if you can, like the little truck, a generator and............ the bike. Lack of space to actually start to move things around to organize is a big roadblock. I constantly have to force myself to do a semi annual...

I did have one on Fordifications but it had a stroked small block in it at that time

Thank you for the kind words. Your in the area as well?

very nice! single turbo? my neighbors BIL has one set up for strictly strip as well. It's amazing the horsepower they can generate. Push out many head gaskets?

70 Torino, 67 F-100 with a 98 mark viii driveline, 2005 crown vic squad car front clip. I was at home depot today, no luck. Going to try Tractor supply Thanks for the compliments, but when my garage grows up it wants to be a real shop like Billy's. Nice set up sir, and very clean. Whats under...

it's an older unit from the mid eighties, they had a system one (heavier lifting capacity 7,000 lbs i think) and the little brother system two. I paid $800.00

AVC, yes, I had no choice, had to split the difference. It's not a true all the way thru control joint though, so I'm pretty confidant. Do you get much fore/aft rocking with any of the vehicles you've lifted so far? Krash, thanks for the compliment, more people DONT know what it is than do...

http://i165.photobucket.com/albums/u63/BlueOvalDave/daveiphone2137_zps65e1cf6b.jpg http://i165.photobucket.com/albums/u63/BlueOvalDave/daveiphone2138_zps61acb2a3.jpg well, keeping my fingers crossed. Definately want to find some tall screw style jack stands to take out the fore and aft...

If by single line your talking about the one that goes overhead then yes. The recommended bleeding procedure is similar to bench bleeding a master cylinder. I'm going to see if I can source the appropriate plastic fittings and some hose and give it a whirl, cant hurt. I'd rather weld up some...

i got it figgered out, (I think).Fluid level good. Carriages are not stuck or locked. I did try to crack open the bleeder on the slave side ram, no difference, I then cracked the overhead line to relieve some pressure and she unstuck herself. I ran it thru a couple/few more cycles (not all the...

locks and carriages are free.

Just finished my install of a used system II 6000 lb two post and was running it thru a couple up and down cycles to equalize/bleed it. It was going really well but now it's stuck in the fully raised position and wont come down. No car on it of course. Any ideas?