wssix99's latest activity

If the wrench has a "GK" in the item number, it should be made by Danaher Corporation/Kingsley Tools. It looks like they may have made...

I had this same problem with the same material. I built my deck just over 10 years ago. It looks OK, but I still regret not leveling...

... and you know that its so suspect that you need to use jack stands. This is good and we should all do it. Its absolutely essential...

Read the thread from the beginning. All your questions and concerns have already been addressed here.

I have used rub-on transfer lettering from model railroad sources.

BTW - Not all Scotch Brites are equal. If what you have is too aggressive and scratches the name plate, you can get finer pads. (I did...

Use water and a ScotchBrite pad. Elbow grease should get it off. If you use a chemical, it will probably take the markings off the...

If you don't understand how concrete anchors work with a lift, we can help you. Please tell us what doesn't make sense. (There are...

Here's an excellent video that does a better job than I did at explaining why a compression brace is stronger. In compression, the...

Its not the axial force on the steel diagonal but the radial forces on the frame. A square tube is probably stronger, but this is more...

Unless you need it for aesthetic reasons, I would put the cross member from the bottom of the hinge post to the top corner of the...

The 4" spacing is the net gap where the child's head would trap. Not the center to center spacing. The picket diameter/shape affects...

You need the switch if you want to change speeds, but you can't run two ceiling fans off a single regular switch. There are $pecial...

There is a short section of good threads behind the chewed up ones. Not enough for two normal nuts, but plenty of good threads for two...