Recent content by yetisas

I have a weird question I have a 44 x 30 x 15 ft ceiling barn in it I created a 16 x 30 x 9 foot ceiling shop I want to install a mini split system for my shop question is can i have the condenser unit installed inside the barn in the open space and run the cooling unit into the shop? The reason...

so technically I could attach the pressure test to the pipe off of the tank?

I have a question would the race deck be a good choice for a wood workshop floor? I was going to go with rubber conveyor belts that I can get from all recycle. But race deck should work as a cushion over concrete to prevent fatigue from standing on a cement floor all day?

This is the setup going into my house. Do I need to do the same at the out bldg? What is the tank for? Can I install the new regulator in the out bldg? How can I check the pressure coming to the house? Do I need to know that to get the regulator?

awesome

Hi have a question. I have a gas well supplying gas to my house there is a pressure regulator at the house. I installed an outbuilding that I want to supply gas to. It is about 70 feet from the house. I installed a 1" gas line from the house to the bldg. Question is can I come off the regulated...

Hi all, Thanks for any advise you might have. I have a 44x30 barn that I'm adding a workshop in that will be either 16x30 or at the most 18x30 I'm trying to figure out what i need to put a roof over it walls will be 9' high and will have limited storage on top no engines or anything really heavy...

Kenc the double 2 x 12 will be supported by the building walls on one end and 4-2x6 on the other end. storage stuff will mostly be pool equipment, deck chairs and tables etc. stuff I don't want cluttering the rest of the barn. Bob15 the 8 columns your referring to are actually the 2x6's...

My barn measures 44' x 30'. I'm going to section part of it off for a wood shop measuring 20' x 30' with a second floor for storage. My question us can I get away with 2 - 20' - 2 x 12 at the 10' and 20' with 2 x 6. would this be sufficient? Want to have shop with clear span no posts. drawing...

Got mine from US Door here's the address http://usdoors.com/. Cheapest I found around and fast shipping.

After reading and looking through a lot of the posts on this site I've realized I'm in the right place. So I'm soliciting the opinions from the various disciplines that are evident on this site. I have enjoyed reading all the posts, and there sure is a heck of a lot of them. Need some help...

Well I'll see if i can explain better. Normally with trusses the airflow goes from bottom of the roof to the top ridge vent on the roof(like in an attic space). Mine is different in that it's an open ceiling that has metal trusses every 10 feet with 2 x 8 purlins (I'd guess you call them which...

Hey all Need some suggestions for the insulation of the ceiling of my 44 x 30 x 10 workshop. Normally I wouldn't have an issue if the ceiling joists were running vertical I'd just put in the r-19 with vapor barrier and let the ridge vent and soffit vents do their thing. But my ceiling joists...

In the process of giving the garage back to my wife for parking of her car. It's only taken me 15 years to finally start building my workshop 44 x 30 x 10. I've got it under roof all closed in except for the roll up garage door. Need to finish siding, pour the floor or at least the part my...

hey all moved my question