Search results

Hello I am looking for 2 Snap ono and 2 craftsman wrenches. Snap on part #'s OEX-120 OEX-160 and the craftsman 20 and 21 mm raised side. Thanks Ed

I just aquired a 1/2 drive Snap-on L-710. Could someone give me an idea of age and approximate value? Thanks

Hi I just got a variety of NEW Morse taper bits. I am pretty sure the majority of them are Cle-forge. I have to go thru them, but is there anyone here interested? I will probably be asking between $5 and $10 a piece. If not they go to e-bay Thanks Ed

http://www.racingjunk.com/post/1009359/9000lbs-ROTARY-2-POST-HOIST-4-SALE-TRADE.html Found this and thought someone might be interested

The walls are typical pole barn sheet steel with 4x6 poles and 2x4 every 2ft going up. Can I just put insulation in between the 2x4, say 1 1/2 inch foam? Do I need some kinda vapor barrier? I really don't want to stud the walls out. Also for the ceiling I have 4 ft trusses, my thought was to...

I have a new pole barn, and I am looking to get some airflowing thru it. It has soffit and a ridge vent. I am looking into gable fans, but was wondering how do you put a roof vent/fan on a pole barn? I have put attic fans on my homes, but how can you seal a vent on a roof with with ridges? Do...

I just had a new garage put up, and the floor is new concrete. I want to put my GTO in the garage, but like a lot of old cars, she tends to mark her territory, lil oil, lil trans fluid... I have seen a number of mats or absorbing pads for under cars, and was wondering if anyone here has tried...