Search results

I've been unsuccessfully looking for a used lathe for the shop going on nearly a decade here in Eastern Canada. There doesn't seem to be much available, and when something pops up it usually goes pretty fast. I noticed this 13x24 Craftex CX709X on clearance for 3299. There is a note on the...

I recently had a battery that was too drained to charge on my old rusty Schumacher charge. So I figured it was a good time to upgrade to a good quality one. The only issues I had with the old one were, it didn't have manual mode and the steel clamps rusted so it doesn't connect well. After...

Does anyone have a service manual for a Devilbiss 432. I picked one up used for a couple hundred with no motor, unknown shape and questionable tank. I would like to tear into it before I use it, make sure everything is in good shape. The tank pressure tested good to 350psi, and with a bit of...

Just setting up a used compressor (seller said, works good, but motor burned up)and figured I'd at least change the oil before I try to run it for the first time. So what is the standard oil/water ratio you guys use(see attached image). Also, is 1/2" of white sludge in the bottom enough?:wtf:

What would you guys estimate the value of a Colchester Master 2500 lathe? It's old but still in working condition. Any suggestions on what it would be worth?

What would you guys estimate the value of a Colchester Master 2500 lathe? It's old but still in working condition. Any suggestions on what it would be worth?

I got and old GE motor starter with a used compressor. It is a CR206APY CEMA size 1-1/2, good for 5hp on 220VAC single phase. Looking at the mag starter there is an extra part that I don't recognise on the left circled in blue in the first image. Can anyone tell me what it's for? It kind of...

I recently purchased a old Webster compressor, I think it is a model 60 based on previous thread saying the first to digits on the serial number(601078) is the model number. It came with a 2HP-1800rpm Doeer motor that had the smoke escape. Does anyone have information on this compressor, what...