Search results

I reorder mine from Mcmaster Carr when needed. I don't believe it mentions it but I always get a Norton wheel.

Has anyone used the miniature inline air regulators. If so any pros/cons or feedback would be appriciated. I am looking at the one from McMaster Carr, item B from the link below. http://www.mcmaster.com/#air-compressor-regulators/=nvqzxw

Thanks. That's what I was looking for!

I am looking at adding a few quad outlets in my weld/fabrication shop. I am no electrician by trade and was curious to know how many quad outlets you can run of a single breaker. Typical plug in items would be 4 1/2 angle grinders, radios, fans, etc. No heavy draw items. I didn't know I there...

New tools added!

New tools added!

New tools added!

Tools still available. Will be posting more this week. I am also open to trades. Looking for 1/2 MM/SAE 6 point shallow and deep socket sets. Also 6pt 1/4 drive deep socket set.

Still have some tools available for sale. I am also open to trades. Looking for 1/2 MM/SAE 6 point shallow and deep socket sets. Also 6pt 1/4 drive socket set.

Some tools that were pending are now available again!

Some tools that were pending are now available again!

I am currently cleaning out my tool boxes and garage. I am attempting to consolidate power tools and go with 1 brand. Paypal accepted for payment. ***** I am also open to trades. Looking for a set of the Craftsman Industrial metric wrench sets everyone was getting through Sears Outlet.*****...

I am clearing out multiple tool boxes and garage. Everything here must go. I feel items are priced to sell, but if you feel they are not low please make a reasonable offer. PayPal accepted for payments. Shipping will vary on tools purchased. Craftsman Open End Ratcheting Wrench Set: $10 8-10...

BLAH BLAH $$ BLAH BLAH BLAH $$

Go with a Geka, we use to have a Pirahna, and sold it. We now have 2 Geka Ironworkers, things are rock solid.

I am looking to buy 2 snapon t-handle storage trays that the new stets come in.

Hello everyone, been a member for a little bit now. Very addicted. Do alot of reading, but don't post all that often. Anyway I am looking for a allen wrench (L key), that has a screwdriver handle. Not the usual hex drivers, this is an actual L key allen wrench with a screwdriver handle. Tried...

We use Duracell Procell @ work, no complaints about them. Usually on AA and AAA, have D cell but I personally don't use the D cells.

Dead Blows, unless you count today....picked up the 41 inch red toolbox.

About 70% of the fasteners I work with are hex. I just ordered the VIM set mentioned above, have not received it yet. My other sets are Wright Tools (3/8 dr, long and standard), Gearwrench (1/4 dr, and Kobalt (USA, long ballend). I use them all depending on the job, but Wright set is my favorite.