Search results
-
O
Heater combustion air inlet size requirement.
I just received my Sterling GG 120k BTU propane heater for the shop and came across NFPA specs on combustion air intake area requirements that contradict the manufacturer specs. The manual states the NFPA requires 1 square inch of intake area for every 5,000 BTU input rating of appliances. At...- OH_Varmntr
- Thread
- Replies: 3
- Forum: Heating and A/C
-
O
Well it's happening...my 48x60 build
The survey is done and I'm all set to begin. But before we break ground I'm going to clean my front yard up a bit by having my current overhead 25kva service primary buried. Before my house was built there sat a trailer in my front yard and it was fed via this overhead service. When the house...- OH_Varmntr
- Thread
- Replies: 196
- Forum: Garage Gallery
-
O
48x60 layout
Finally getting some final plans put together for a building and have a layout in mind. Trying to nail down the location of the lift so I can pour 6" thick concrete there. I know, I know, 4" is all that's required. The location of the building limits vehicle entrances only to the side with...- OH_Varmntr
- Thread
- Replies: 26
- Forum: General Garage Discussion
-
O
Planning a 54x60x14 shop.
Still in the initial stages of getting quotes for a 54x60x14 shop, finished in different degrees. I had a Morton rep out nearly 2 weeks ago and although I've tried to get back in touch with him, I've yet to hear any numbers. Not really a bad thing I guess as I am getting jerked around by my...- OH_Varmntr
- Thread
- Replies: 10
- Forum: General Garage Discussion