Search results

Thanks Nitro I've already let it cure for 45 days. I still need to plumb and finish out the electrical. Then insulate and finish the walls. I am planning to install a two post lift in the center bay Need to hang the lights and other assorted items. Then install hvac system. That should...

I have built a 44 x 28 garage and am still deciding how I want to finish it out. The question I want to ask is should I go ahead and finish the floor now or wait until all the trade are done? I can see some pros and cons for each. Thanks for the thoughts.

It really depends on the R-value. Installed or DIY? Recently installed three CHI doors and they were considerably more installed but included jack shaft drive motors and remotes. They had an R value of 17 though.

Thanks for the replies. I will most likely do both after all the overhead (walls, ceiling, etc.) work is finished. Probably torch it, then screen it.

Thanks Any suggestions of systems or any other advice would be welcome.

I recently built a 28' x 44' with an interior wall and 12 ' ceilings. Basically a two car and a one car garage side by side. I would love to know what size unit I would need to work with this.

Thanks Rugerlady, How much heat is necessary to burn off the fibers after profling? Is there any special/prefered equipment?

Has anyone used the supercoat kits through Sam's Club? Pros and Cons?

Finally started the shop but have some questions. Tech support has warned me of potential issues with fibre mesh and epoxy. Has anyone had problems with "fibers" standing up and having to sand between coats? I am planning a 2 room 3 bay garage (28 x 44) and want the floor to be easy to...

Motorcycle79 - quick questions about your mitsu mini. How much did it run you and where did you find one? What sq ft will it handle? Thanks for the help