Search results

That one IS a keeper. And open end wrenches never had " flank drive" only box end and sockets. "Flank drive plus" is what came out on open ends in later years. The slots at 90° to the edges. That wrench at an estimate is at least 60-70 years old Sent from my iPhone using Tapatalk

wyliesdiesels. I also noticed the large terminal at the top of the RH neutral bar and quit looking. ARGHHH electrically with this panel as a main it probably makes no difference but esthetics wise I would have had a more warm cozy feeling if the braid had been connected there Sent from my...

wyliesdiesels. Now that you pointed it out I jumped on lap top instead of iPhone and saw the neutral. Excellent catch. I was really a little concerned over my last 50 years of learning. Lol thx Sent from my iPhone using Tapatalk

Call me stupid here but I'm curious if this panel is supplied direct from a meter base. I got the 240 part down. BUT I see some 120 singles in there but no Neutral from said meter base coming in. Am I not seeing the obvious here. ? Sent from my iPhone using Tapatalk

Under the use you indicate. I would do ok with a 125 sub panel with heavy enough wire. Sent from my iPhone using Tapatalk

Side thought. Don't use chrome sockets on an impact gun. They may break and for sure the springiness reduces the force Sent from my iPhone using Tapatalk

To put a switch and use 120 volts or 240 since you're activating only the contractor coil, 14 is sufficient but not to operate the motor itself Sent from my iPhone using Tapatalk

Not bothering anyone. I'm sorry for the loss of your little girl. Her pictures are so cute. Hoping for some good design and it's an awesome Memorial to her Sent from my iPhone using Tapatalk

My "Puma" 3HP 60 gallon does this also on the generator. Which is aB&S 13.5 kw start and 10.5 run with 27 HP Honda engine. Completely disconnecting th 3/8s discharge line from compressor head it cannot overcome the compressor friction and inertia on startup. The genset doesn't even pull down...

The whole thing looks Craftsmen Sent from my iPhone using Tapatalk

Look on the back upper corners. Usually a printed label or model and paint code stamped into back Sent from my iPhone using Tapatalk

Since when is #14 rated for 20 amps Sent from my iPhone using Tapatalk

He did a good job on the video Sent from my iPhone using Tapatalk

Vacuum tube sockets. Oh my you are old enough to remember tube testers in the hardware stores Sent from my iPhone using Tapatalk

You can test it with test stops and you can use a voltmeter with one probe in the coolant and a probe on god of connected battery. More than a couple of millivolts and the coolant is causing galvanic action on parts. Sent from my iPhone using Tapatalk

I had a father in law bought a half inch DEWALT corded drill to drill holes in retainer wall ties. Put tape around the chuck and plastic bag around drill and got a full day before it overheated. Took it back for a full refund. ******* Sent from my iPhone using Tapatalk

I've had this happen at Menards also. It's like they don't check it when returned or someone from the store borrowed it. Bought a laminated floor saw that ended up showing blade wear and bent track piece. Only one left Sent from my iPhone using Tapatalk

This is the way of the can't fix it generation Sent from my iPhone using Tapatalk

I use #12 for most everything 20 amps or less just cause I don't have to worry about it. Sent from my iPhone using Tapatalk

I have watched many of these reality shows and all of them that survive a few seasons greatly increase the " appearances" of every aspect. Even Ice Road Truckers and Alaska the Last Frontier Sent from my iPhone using Tapatalk