Search results

Nope, just one coat of Behr Premium plus (interior). I used a little over 10g in my shop. I did caulk the seams as well.

Here is how I did my leanto. This is how I would do it again.

I painted the OSB in my shop. Overall, I am very happy with how it turned out. This is 1 coat of Behr interior paint.

I used GRK cabinet screws to hold my 1/2" OSB up. All my electrical and air is run in the wall.

Here is a picture of my installed units. I have (2) 18k btu mini splits in my 1600 sqft shop. It has 14' ceilings.

Here is a pictures of how my fans are installed.

This picture might make a little more sense. This is how I had my overhang framed.

Ecobee

I made my overhand 1' shorter on the front and back. This was done so that the corner trim can be continuous from the roof to the ground. It makes for an overall cleaner looking installation and gives the gutters a place to run from the roof straight to the ground.

I have a 30x60x14. I put in 2 of these in the 60" version. https://www.marleymep.com/products/leading-edge/heavy-duty-commercial-ceiling-fans

I have a 30x60x14 pole barn. I insulated with R-19 wall and R40 attic. I use (2) 18,000 btu mini splits to heat and cool the shop. I supplement with (2) 60" ceiling fans. I have not used the system in summer yet, but I do not anticipate having any issues. The units work great for heating...

I have a 30x60x14 pole barn. I insulated it with the help of a few friends. I used R19 Batt in the walls and blown fiberglass to R40 in the ceiling. It cost me just under $1800 dollars and 2 days worth of work.

I wish I would have supplied the man doors and windows and just had the builder install. The builder grade doors and windows drive me crazy everytime I am in my shop.

I am going through all of this right now. I just built a 30x60 shop and installed a 100 amp panel. I thought I would be able to interconnect my solar to my shop, but was introduced to the 120% rule that has been mentioned. Also, our local utility wanted the solar disconnect adjacent to my...

I looked at these, but it appeared they could not be surface mounted without buying an additional bracket. Is this true?

Ya, that was my main concern as well, but I really like them. I bought them through Amazon so I figured I could return them if I did not like them. I also liked that they used the LED tubes instead of integrated LED's. I want to be able to replace components if I need to.

I have not seen these fixtures talked about much, but I purchased the Primelights 6 bulb. I am very impressed with these fixtures. I have put in 6 in my 30x60 shop, I think I am going to add 2 more over the garage doors in the future...

I went with the 6 bulb because I wanted to install few lights. I am really have with the 6-bulb, they are very bright. I think I am going to add (2) more over the garage doors. I am going to try this out for a while before I do this though. The fixtures are well built and I really like the...

My electrical rough-in inspection has been passed. I am hoping to get the final electrical inspection Friday. My final grading will be done tomorrow and they are going to bury conduit for my solar system tomorrow.

I was able to get quite a bit more work done over the weekend. I trenched in all of my downspouts and drained them into the pond. I think trenched in 2" conduit for the feeder from my house to the shop. I then started pulling wire and doing some framing so I could put in junction boxes...