Search results

I am looking to buy a new compressor. I prefer Ingersoll Rand. But can not find a model I like. Does any one know what model would be a upright, W/175psi? Allso what is the best motor.I was planning on putting it outside. How have you guys got the plumbing run through the walls?

I had my concrete poured yesterday. Lastnight I flooded it good. Is this enough or should I put water on it for a few days? Thanks in advance

Will the copper hold up good? I am afraid of a leak being under the lab. There Is only about 3ft under the slab.

My plumber used 3/4 inch copper line to supply the garage. I have 1" pipe pvc pipe coming from the meter to the copper. Will this make me lose alot of pressure? The only reason I can figure he used copper is because this supply line will be under the concrete.

My contractor put #89 gravels down then ran the plumbing, then put #59 gravels down. Will the large gravel on top be a problem? there is a total of about 8" of gravel. I am used to seeing the smaller gravel used.

Same as what my reps. tell me

I am getting ready to pour my concrete. The contractor came out this morning to put the garavels in. It is very wet and they are tracking up mud bad. Will this efect the concrete pour? Thanks in advance.

Looking good. I am getting ready to pour my floor. How long should I wait before I start To water after it is poured? Just don't want to leave spots in it from the sprinkler and water.

I am building my garage now. I thought about putting my comp. outside, but I don't know what kind of comp. I will be using. What would be the best way to stub a pipe so That I can tie on to it? Just didnt know if I should put it low or high in the wall.

I was wondering if anyone has a hot/cold outside water faucet? If so what kind. Also pros & cons of it. I have thought about installing one for washing cars.

I finally got some prices on doing my floor. Tell me if this sounds like the normal price. $8000.00 - $12000.00 for a 2000SQ FT floor. I was looking to do it in epoxy W/ paint chips. Seems high to me

Does anyone know of any floor coating contractors in the southeast TN area? I did not think it would be this hard to find. Thanks in advance.

I am in TN.

The soil below the footer is very compacted, also used 2 layers of steel in footer.

Started to lay my 3 course of block. Noticed the footer had crackes in it. It was poured last Wed. Is this common, or will it cause a problem? seem to be top layer cracks.

Getting ready to start framing my 34 x 60 garage. I thought now would be the time to run the duct work for central heat & air. Has anyone got any ups or downs about putting it in a garage? The garage is 34x60 w/ full up stairs. Would it be pricey on the electric bill. Thanks for any info.

I have a contractor building my garage. He said the footer will have 8" of concrete. Is this enough? The garage will be 2 stories

I am going to start building a garage in a few weeks. I was trying to decide, build it out of split face block w/ brick front, or vinyl sidding w/ brick front. I even thought about going just all vinyl.What does everyone think would be the best way to go? Allso want it to look good. Price is the...