Search results

If I understand what you are trying to accomplish is to turn the motor on and off via the toggle switch, , , , , Disconnect the black wire (power in to the motor) and put it on one side of the switch, , , ,you will need to get a piece of wire of equal size, , connect it to the toggle switch and...

Same as before , , and if that is a jack stand, , , , it looks kind of sketchy

I concur with MTW, , you need to make it right by code before some one gets hurt really bad , , , , no piling on just an observation, , , Agree with hh76 as well, , I've never had luck fishing a conduit with existing wires, , , it takes less time to simply pull them out, , then pull them in...

I just bought another Acton, ,smaller handheld 9575, I can't remember but I think it's updatable via the micro usb connector, , good for what I use it for, , , , , I'm thinking it was around $120

I have had success boiling it in water, it will take some time as it appears to be pretty thick, ,

Welcome rgs455

Is the operative word " under pressure" , , you can have your hot water heater produce hot water in excess of 140 degrees , , ,

Alibaba says $50 +/-, , , ,

Trout fisherman , , , , welcome , , , ,

That's a really clean lathe! Wish I owned it.

What your asking for is reasonable, , , the question you need to ask is If the community has an HOA, you had better get a copy of the bylaws, , as they will dictate what you can and can't do, , regardless of what the Project Manager promise , , you may not be able to leave your garage door...

These are "almost generic", just get one from another motor , , you'll be happier you did it, , , almost any bone yard will have an old motor junked

OMG! ! ! It's an epidemic. , , , , , ,

Isn't that called "having a senior moment"

Breaker trips and or things get hot and catch fire

Made you jump a little, , hate when that happens, , ,ruined a good set of cutters, I bet:wtf:

2 stage compressor, , high cfm

The one pictured above can be picked up at napa , , , put some type of lubricant on the spot weld , , , ,if you use a center punch first it (put a punch in the center of the spot weld) will keep the cutter from wondering around when you start to cut

Nope, I disagree, , get some soapy water and a paint brush and brush all the fittings with soapy water and check for bubbles, , start there, ,