Search results

This 4300 B&D sharpener is for parts or use as is. Actually runs very well and will sharpen drills. However the Dress/Sharpen (D/S) lever does not work. User manual and parts breakdown included.. New drill index guide installed . Wheel appears to be new. $100.00+$25.00 shipping. 18# or pick up...

I have an older 1 1/2 ton SJ 2 floor jack that I need parts for. I would like to find a complete pump assembly. which may be part# SJ 1.50A. This is actually a Sears & Roebuck jack( Model 727.12101) that was made by Blackhawk. Bought this new back in the 1970's and is a really good, heavy duty...

I have two of these jacks and having trouble with one of them. (Blackhawk SJ2) Recently had the jack mechanism apart to seal the tank as it was leaking at the base. Got this sealed OK now but on the first 6-8 stroked it raises normally then raises a little less with each stroke unless you wait...

Installing a new ventless propane heater in unheated section of my garage. I have 1/2” copper tube and also some 3/8 copper pipe. Of course the hard copper does not flare for gas fittings like soft stuff. Any issues with flaring the hard 3/8” pipe so it will flare like soft tubing does? I...

Got this jack (only the jack) back from the rebuilder. Had to take him the jack only as he did not want to disassemble and assemble the jacks' framework. Jack came home empty and off course, untested. Put it all back together today and it sort of works! 1st stroke of the jack raises the saddle...

Placed a WTB for a tool in the "General Tool Discussion" because I could not put it in the Classifieds. Note in the classifieds stated that I had to have at least 100 posts before I could place anything for sale in the classifieds or WTB......why that rule ??? Jerry

Going to buy a used WA-92 Snap On coil spring compressor. Thought I'd look here before going the e-bay route. Anybody out there with a nice one? thks Jerry

Wanted 66 Pontiac tri power intake and carbs. Want complete setup as possible. Will consider just the correct carbs as well................... Anything ?? thanks, Jerry

Hiball: if you can hear me I need repair kit for an older Walker J 134. Thanks, Jerry Well

WTB: I cracked the 1/4" NPT inlet port on my new Carter fuel pump the other day. This inlet is on the very bottom bowl of the pump and this bowl is roughly 2" in diameter and the bowl is held in place with two vertical screws. If anyone has an old pump like this lying around I would be...

Good morning, all: Hoping Hiball sees this and responds. I have two of the above jacks whick I believe are actually Blackhawk SJ-2's Both are leaking pretty bad and need parts for rebuild. If Hiball has a business phone or e-mail address, I would certainly appreciate it. Thanks in advance...

Hello guys & gals. Visited this site a few times, but my first time to post. Couple years ago I installed 4 new 8 ft florescent lites in my tool room. I used HO fixtures so they would lite better in cold weather. Love the light, but it messes up my FM radio reception when they're on. My 4...