Search results

The handle for the tilt wheel on the left side of the saw came off and I cannot figure out how to repair it. I assume the wheel comes apart some how but it's shown as a single unit on the parts diagram

I have a Craftsman 319.211260 6-inch bench grinder. While buffing out a part, the part slipped and jammed the right side wheel. It stopped spinning but the left wheel kept spinning. Did I shear the rotor shaft? Is this worth repairing? Thanks Jeff

I have a GE compressor motor that is running very slow all of a sudden, even when no pressure is built up. The motor GE Model 9033 5KC49NN2050Y (wired as 120v) that's maybe 10 years old. I'm assuming its the brushes but I cannot figure out how to get to them. There are 4 front to back bolts but...

I'm using a vintage oscilloscope (Snap on MT3000A) on a vintage car (Datsun 260z) to analyze the ignition. The ignition was changed to a Mallory Unilite breakerless distributor with a Mallory coil. The secondary wave plots from the 6 cylinders look different from the oscilloscope manual in that...

I recently acquired a Snap On Counselor 2 Analyzer that I'm trying to use on a Datsun 260z and could use help in interpreting the results since I haven't used a scope since the 1970's. The Datsun as an aftermarket Malory electronic ignition. If I'm reading the secondary wave form correctly...

I"m looking into installing a lift to use to store an old car over a new car in my 2-car garage. I have a high ceiling but will need to modify my garage door tracks to make the extra headroom usable. The prices and I assume quality cover a wide range. The best price appear to be at...