Search results

Amazon Woodcraft Craiglist

Just looked it up. My saw runs at 4000 rpm compared to 150 rpm on the cold saw.

I have a Dewalt abrasive saw. Can I. Swap to a tungsten carbide on my saw?

Here's my solution. I bought the hangers but you could easily make your own using 2x4s.

Check out the graphics section. http://superiorrestoration.com

I paid $64,000 for a 30' x 32' x 12' in the Texas Hill Country. This was a masony (brick) building with a roughed-in full bath and kitchenette with cable TV, 200 amp service,internet, phone and full security system. I then spent another $20,00 for insulation, sheetrock, painting, full...

I needed storage room in our bath but didn't like the look of a medicine cabinet. I increased the opening and installed a new header and rather than use a regular door, I had a custom frame made and used Chinese print we bought from 1 of our trips to Hong Kong.

I used 36 6" can with less in my 30 x 32 x 12 woodshop. I used airtight IC rated cans as the shop has central air. Pic is in the early stage before flooring and trim out. I didn't want the fluorescent lights to be hanging down and getting in the way when moving sheets of plywood.

I do a board similar but I do a end grain board. It starts with the same board as yours but after a few cuts, it ends up looking like this. Gilbert

Do you have a pic of the frame without the toolboxes?

Has anyone tried that with Cherry?

I added a double thickness of 3/4" PDF, and covered with Formic.

We just installed our Ac 2 weeks ago in our woodshop and we were also worried about getting dusts in the ducts. We had the installers add 2 12" x 12" filters and a 12" x 30" filter on the return air ducts as well as a 4" x 20" x 20" filter at the air handler.

I bigger hose is better if you're watering over 200 feet from the spigot.

I also use the Lowest NeverKink Max. I have 2 of the 100' and 2 of the 50' hoses and I am totally happy with their performance. They actually never kink!

I got Ac in my shop last week and I know you'll enjoy it. I added a 2 ton heat pump in my 30 x 32 shop.

Very interesting reading. Thanks.

I've had the 8 piece pliers set on order for 2 months and it's on backorder. Sears has no idea on when the new manufacturer will deliver the tools? Anyone know who will be supplying the tools and who was making them in the past?

I also have 13.5' walls and did the high lift. You might want to consider not adding the door handles. I had to remove mine after the conversion as the door goes straight up and hugs the wall.

Our home has an attached 800 sqft garage with a 960 sqft workshop and a 450 sqft garage at the back of the lot.