Search results

Search the forum Search Articles
  1. C

    Feit Electric T8 LED Fixtures at Costco

    All my local Costco out!
  2. C

    Feit Electric T8 LED Fixtures at Costco

    Amazing light. Hard to imagine that you could run that much light off of Hondas smallest genset with a single zip line plug!
  3. C

    Feit Electric T8 LED Fixtures at Costco

    Very nice light indeed! Not near as "cool" as Cool White. I bought three just to check the color and output. Eight more sets and all my lights will be replaced!
  4. C

    Feit Electric T8 LED Fixtures at Costco

    Ahh.
  5. C

    Feit Electric T8 LED Fixtures at Costco

    I can't find anything at Costco under that number? Any links?
  6. C

    Las Vegas Tool - Easy Puller

    I used it today! I pressed a plastic piece into an aluminum frame upside down.. Twice! I have the tool for that! Popped them right out!
  7. C

    The Best Files

    I like FDick. http://www.riogrande.com/category/tools-and-equipment/120/files/310/friedrich-****-hand-files/5594/
  8. C

    Fein Multimaster 250q START kit: $85 shipped

    That thing is a beast! Any recommendations for a good quality set of assorted blades?
  9. C

    Fein Multimaster 250q START kit: $85 shipped

    I got one.. Not sure I even need one.
  10. C

    Tips on Cornerbalancing??

    Oh yea. Disconnect the sway bars.
  11. C

    Tips on Cornerbalancing??

    Get them level! I'm guessing you don't have slip plates? If not, I just took an average of three loads/unloads to get close. Remember that your camber curves get funky as you lose travel. Everything is a compromise. Work in small chunks. Be prepared to spend all day the first time.
  12. C

    Anyone else surface heads the hard way?

    Yup. Suburu heads back in the day!
  13. C

    It's a freakin' LASER beam! (Laser engraver / cutter)

    That is so cool.
  14. C

    let's see your craftsman block grinders

    I did. Nothing under 397.19580.
  15. C

    let's see your craftsman block grinders

    Looking for a replacement left tool holder for 397.19580.
  16. C

    Internet to Outbuildings Using Wireless

    Been there, done that, got the sticker and the Tshirt.
  17. C

    Internet to Outbuildings Using Wireless

    I had issues with Nanostations that were too close.. They could not handle the high signal and the noise floor was too high. Switched to the new Nanobeams and problem went away. Just FYI.
  18. C

    Best .105" trimmer line?

    I'm using Husqvarna TitaniumForce trimmer line and it is the best I have found. Any wisdom?
  19. C

    Need to get internet & phone to shop - 500+ feet away

    Nanobeams at 99.00 per side should give you the headroom you are looking for. GbE on both ends. Amazon.
  20. C

    Air Compressor drain

    Something I need to do.
Top Bottom