Search results

Just got this old wood creeper with a wheel missing and one broken off carriage bolt pictured for reference. Does anybody know where to source them? McMaster-Carr doesn't have them, but they do have the exact wheel I need (although somewhat pricey). If anybody is parting out one of these...

Just got this old wood creeper with a wheel missing and one broken off carriage bolt pictured for reference. Does anybody have a pair of these fasteners or know where to source them? McMaster-Carr doesn't have them, but they do have the exact wheel I need (although somewhat pricey). If anybody...

BUMP. Have the 7/16 and 5/8 now....still need the MEB10L 10mm....thanks.

A good friend of mine has two Bonney combo wrench sets and needs the following to complete them: MEB10L (10mm, long pattern, 12 point box end) 1114H (7/16", long pattern, 6 point box end) 1120H (5/8", long pattern, 6 point box end) Attached is pic with two of his wrenches for reference on...

BUMP. Can anyone recommend a home machinist on here to make one of these screws?

I paid roughly $60 for this LOCK-017C tubular lockset and MLRA-005 adaptor. They did not work with my '89 MB1440 rollaway, so I'm offering them up here. The threads for the adaptor nut have partially stripped on one side, but the nyloc nut still tightens down ok. The adaptor will mate this...

See pics. I need ONE cheese head machine screw....oddball 11/32" diameter shank, 16 TPI, and 3/4" long under the head. This appears to be an obsolete or proprietary thread that I cannot locate anywhere. If you are scrapping one of these vises or know where I can locate this screw, any help would...

The M9 (fine thread only) isn't close to this.

A 5/16-18 fits, but poorly....noticeably loose.

I'd have to know what I was dealing with to make one, and don't want to booger an original hole to fit a larger fastener.

I'm going through a vintage Walworth (Boston USA) pipe fitters vise for my buddy. It's missing one of the fillister head screws that hold the jaw pads in. I thought it was a regular 5/16-18 thread, but noticed that my thread chaser was loose in the holes. I took measurements as follows: shank...

My recently acquired '89 MB1440 rollaway has a bad pin in the lock cylinder, and now it's blown apart. Key code is MAT 1. Does anybody have a functioning cylinder/key like this? Thanks in advance.

Ended up getting the IR attachment, tried it out today on a crusty brake rotor....works about as well as expected.

Do you have the part # on that? Thanks

Just found this thread while looking into a scaler attachment for my Blue Point AT2050....do you have any recommendations? Snappy offers the PH201....but it's $375 and on back order. I would be using it infrequently. Thanks in advance.

Thanks fellas.....looks like I can get the 6 50 plug at my local Lowe's.

I was recently given an early 80s Sears ac welder for free. It needs a couple minor things (was told it worked good), but the style of plug on it is apparently not common anymore. My shop right now doesn't have a receptacle for it and it doesn't fit with the dryer receptacle in my apartment...

Looking for a clean KRL7015 in the standard Snap-on red finish. I'm located in the Lancaster, PA area....but will consider shipping on units farther away. Thanks in advance.

The diaphragm is located between the plastic upper part of the switch that contains the electrical connections, and the the lower metal portion that plumbs into the tank. I know for sure that is what is leaking because I have dealt with it before.