Search results

Well, I finally am going to get a set of torque wrenches...1/4,3/8 and 1/2". Was planning on spending about 300 for all three, they will get used a few times a year...I would like to get a decent set...if I need to go up a few bucks I can... I searched the threads here...alot of suggestions...

Been looking for a larger rotary hammer for a while. I have a smaller version of the same make...in SDS Plus which is the RH432VCQ... The SDS Plus just can't really bust up concrete in post holes, around remodel projects and has limited bits for digging... So I want to switch to SDS Max...

Well, after 14 years the old pump stopped pumping... I am near a lake and must pump the septic effluent away from the edge...so I lift about 40' feet and about 400' horizontal... Old 1/2 horse worked great(Gould pump)...guy came out and pulled old...put in new...sucked down about 20 gal then...

I need a smallish portable generator for very occassional use. Looking to get something I can throw in the car...and basically use to run a heater (110v 8 amp draw) or lights when power goes out at our mountain cabin...or the occasional camping trip. No need for a big generator...just the...

I have ABS on the second floor running in between the floors...noisy down stairs... I have plenty of room to add several solutions like extra insulation, spray foam etc.... Any suggestions are welcomed to help quiet the water flowing noise...thanks

I have usually bought Craftsman ratchets and socket sets, impact too. I have been checking around for some new sets for my new shop in the mountains. So this is a second set of tools I am going to build up for working on my tractor, boats and truck. I have found some SK sets that are nice and...

I put down this epoxy about 10 years ago. It has performed well but it has finally started to get to the point of needing refreshing. I am only going to redo the main exposed area shown here where the Tahoe sits. Basically to the mats on either side so I don't have a old/new seam showing...

I have a Jet J2550 20 inch drill press. I use it a fair amount for basic drilling up to 1" holes ( w/ pilot holes as appropriate ) in hot rolled steel mostly. It's main function is mostly milling stuff I weld up for projects around here. I want to upgrade to a keyless chuck ( I think) or at...

I built this a few years ago. It has a 32x56 floor downstairs...and an 1,100 square foot loft which has been finished out as a game room for my boys. I'll post a few more photos.