Search results

U.S. JACK makes a couple that have an internal spring retract.

New casters for that jack would need to be hand made. Can be done.

A drum brake hone works well to go over the tube for the ram. You will need to work with the leather cup for the ram to soften the outer edge. Oil will let you "work" it and get the cup started into the bore. Don't spoil the leading edge when installing it. Only great reason for removing the...

A set of custom shorter balance cables WILL be an issue every now and then. Top of travel safety MUST WORK EVERY TIME.

Your grandkids will thank you someday!

Are your bolts the normal 3/4? If you are getting 1 inch plus holes you may neeed to move up to one inch bolts so that you can use the holes you have done. Holes in baseplate may need drilled out to fit as well.--- you do want to drill the holes ALL THE WAY THROUGH THE CEMENT. This way if the...

Looks like a 882 walker 2-ton. Lucky find! Great price too.

Kit pn 240530. Easy to kit but be careful of the gland nut with the wide slots for taking apart. VERY tight and very hard to replace. Several types of that gland due to age. Some have the o-ring on contact with ram and older ones have a second ring to unscrew with packings under it. The packing...

Much better jack than most out there.If it has the older style tank nut with the slot to loosen it there is a tool for getting it loose. Please do not use a chisel and beat up the nut. They are getting hard to get.

Wilsonart and Formica both allow overlay of old surface. How you deal with the newly raised edge height is a bit of fun depending on the style of the lip edge.

Can yo cross-corner measure the framing hole to insure that the upright studs are plumb. The framing sounds out of spec. Am betting that the door is square and the jamb can be a bit out and still work for you. Earlier post of just fitting the door to the hole may be all you can do. If the hole...

Lincoln 240530 kit. Many places to get it.

Just build support walls to hold up the deck you want and tie it together with enough decking along the rear wall to be able to walk from one upper side to the other. You will get tired of going dounstairs then back up to the other side. Besides that deck will allow under lighting for work bench...

It is a Walker 93711 early number was a J-44. Don't have a date yet but am digging. Really nothing to go wrong with these. Great jack,,, shame they could not remake them.

Just watch the cables for wear. Frayed wire will make you bleed as you run your hand over it. Watch them for damage. Replacement is no big deal, may want to do this while you have the lift apart.

Y ou will not like the price but look at the GRAY HTJ-1000. It is the best and the air lift for the first stage is very nice. Hand pump and release go up with the load and are smooth. Money well spent!

Some little kid in China has the parts in his pocket! I would like to know who he is too.

Should have the casters used/maybe new. the little clips are all over. Voris hyd Springfield Mo 417-869-7933

You got lucky on the unit tube. Many are ruined by condensate moisture on the slack side of the ram piston.Actually you can still get a new weaver jack and it still looks very much the same.

That screw is the check balls. If you open it DON'T lose anything. Most of the really cheap jacks do not have an overload.