Search results

If you really want to rebuild it get the kit for it. H-F gear tends to use odd size seals and a lot of time can be spent finding the odd stuff.

Am on a hunt for a one inch deepwell full broach socket. Have a Craftsman that is starting to crack and a replacement would be nice. Have had no luck yet.

Blackhawk is now part of Shinn fu. they know nothing of their past. Damn shame.

Watco was one brand sticker that was used on it.

Teen age daughter???

Small three finger drum brake cylinder hone works well for the pressure tube. As you brake the glase on the tube wall look for any minor pitting in the tube wall.

Another vote for Weaver. The serial number is on the right side of the frame at the rear. Can be hard to notice. A really old one will have a wider spread caster mount than this "newer" style. Still made very much like a 40 year old unit. Worst issue with them is moisture caulsing rust in the...

When that release is hung up , you will need to remove it and see that you have gotten it mis-ajusted. It is basically a left hand thread and is easy to set up "backwards". It is easy to get too much movement when letting the jack doun. Shame the threads are not finer. Have seen top of handle...

That fluid that "shoots "out each time is the amount of fluid that is bypassing the piston seal each lift. It is short timing and will only get worse. Be glad it did not have a bypass tube back to the tank. It will hide the leak but keeps the floor clean. Some shops will charge over $150 to fix...

Nope. told him I was not the guy to make him money every time he stopped. Stilll treats me well and the deals are ok. Also can call him and he appears as asked.

Shame you could not get the H-W to Missouri. I would see that you got the repair under the warrenty. I work at a repair center for H-W.

Your grandkid will thank you for the H-W!!!

Did you remember the ball under the release u-joint? If you lift the ram up by hand and it will not stay it should be either the release ball or the upper check ball not seating. If you damaged the ram cup it may recover it's shape with a bit of pressure but it should move with no load but may...

Hard to retract usually means that the heel plate is swelled and binding in the pressure tube. A new one is in the kit. You are lucky that you have the hex shape gland nut, much easier to deal with. Takes a lot of force to loosen. Metal to metal seal for the tank. Yes you are missing a retract...

Nicest heavy duty build I have seen for a long while. You can store engines up there with NO worries!

Pictures are the key

No name pumps are on ebay cheap. You can match up a pump by pictures.

You can use full air line pressure on the cylinder with no harm, it it runs at over 3000 psi.I doubt it will lift at that pressure!! It is possible that the pickup screen at the bottom of the pump unit is plugged with fine debris. It is also possible for these pumps to loose prime.. Light air...

Found this tool in a drawer full of punches. It is marked cornwell sds-43. Any idea what it was used for????

Voris Hyd Springfield Mo We have some old stuff left. Comes doun to good luck as it is picked over. 417-869-7933