Search results

Bushing removal tool would be great if I had access to the back side.

The bushing is 1-1/4" long. Has a .060 wall thickness and is press fit in against a shoulder so only .020 is exposed to try and punch against. The other side has a cap on it with a 3/8 NPT thread for a greese zerk. (Sizes are approximate)

I need some direction on how to get the bushings out of the bobtach on my bobcat 743 skid steer.

WD40 work perfect on the inside of the pump. I put a quart in and ran it for 10 seconds drained it, filtered the WD40 and repeated 5 times till no chunks came out. What would be a good way to clean the tank? Horizontal tank, picture looking in through the pressure switch hole

Before someone chimes in and says oil floats on water and not the other way around. That is due to density different between the too. Oil is typically not as dense as water. But if the oil is full if sludge that will change it's density and the water will sit on the sludge.

..

There must be a better way to drain the oil. The oil had a small amount of water sitting on top. I saw it as it tricked out quickly on top of the oil. There was a decent amount of sludge that came out. What is the best way to clean out the dump. I have some diesel fuel that I could squirt...

I came across this compressor when I was doing a search. It is an Ingersoll rand T21 and it looks exactly like my compressor, even has the same plastic guard on it. Main difference is mine is a horizontal tank and this one is vertical tank. Did ABAC make this compressor for IR or does some...

I already have had the flywheel off when I had the tube from the low side to the high side repaired. I simply applied some pulling force against the spindle nut with a short bar and 2 c-clamps and then used a propane torch to heat up the center of the flywheel. Aluminum expands faster than...

There are 13 fins on the top of the head on my compressor and the fins where the headbolts go are knotched down. The cylinder body excluding valve plate has 10 fins on it. How does that compare to the 6000 series?

Based on my research it is an obsolete ABAC model 5000 series. I could not find specs on it or information on parts availability if I were to pull it down and replace rings or reed valves if that is what it uses. Here is what I know - 80 gallon tank - 5 hp Pump up pressure (new gauge) and...

The pump has written on it made in Italy. Which supports that it is an ABAC pump. The mounting holes, approximately 9-3/16 by 7-7/16 does not match up with the mounting specs for the 6000 series ABAC pump. 6000 pump is approximately 9-3/4 by 7-3/4.

I got a response back from Energair. They do not make equipment only control systems for compressors. Dead end. I emailed ABAC pump. I have not heard back from them. Next I contacted Master Tool repair. They had no lookups on my model number and told me Devilbliss was the manufacturer of...

I just sent an inquiry off to Compressed air management. (Energair.com) and I will let you know what I get back from them.

It says oops something went wrong when I add a picture from my file. Let's try taking it and adding it.

I hope the pictures make it to this post

5 horse power, 2 stage, single phase 240 VAC. I sure got that messed up. I would call the manufacturer if I knew who it was. It kind of looks like a T21 Ingersoll Rand compressor. But the mount of the 22mm type from the low side to the high side does not match.

I recently bought a used 5ph, 2 stage, Energair compressor. I have been looking for information on it and have little luck. I am posting a few of pictures on the unit inhopes someone will recognize it and hopefully steer me towards a manual and parts break down of it. It runs relatively well...