Search results

Just replaced all of mine on my Clark three months ago...the new ones do not have a purge button in the middle...that is there for cleaning **** out of the line..in case your tank line gets some rubber in it. The bowl bladders/gaskets are really cheap...but just replace the whole unit..or units...

:thumbup: Owned one since 2008

Nope....I had to cut the back out of one of my epiq cabs...1/8" steel...very well built

Do not be a tool about your tools...this is a tool forum, so if you run into a tool on the forum ignore them and worry about your tools...which it sounds like you do...and good find at the pawnshop.

for 14.5 that is the one with the power bank? correct? I traded in my 76" epiq for 7500.00 (power bank and locking modis hutch) on my new 86" epiq...that list for 14K...and got another 2800 off...my snappy guy sold my trade in the next day for 10k...after he said he would give me 9k for it but...

so you got your avatar a pair of ratchets from a pawn shop??? :lol_hitti Dude...with that avatar you will never get a response..

I engrave all of mine with the word stolen on them..:evil:

would those be Bose 901's from the ceiling?

Half bike half car garage...all bikes built frame up by myself over the past few years..most from wrecked bikes..etc...the ******** is from ********..not built by me...the silver one is the next one up on the lift after the tank is put on the orange one...yet another bike..lol

Re: what did you do in your garage today? and put in air lines, power for both the lift and a vaccum cleaner..regulator..and remote switches thru the tool box ( hidden) because the 50gal aircompressor is hidden in the crawl space above the garage somewhat...all done in two days...and that is...

Re: what did you do in your garage today? ohh...installed some Stacklights...30/30's Got a deal on a huge lot of them ( I would not spend 1k a fixture for the garage) but up an look great..also use very very little power...I can add or take off if needed...

Re: what did you do in your garage today? Installed a 203" wheelbase open front ( no bar ) Rotary 12000lb four post lift with air locks....Nightmare...but done

long reach seal press?

Looks OK...Just a few things...loose the Romex markers, and zip ties...no need to mark your grounds just mark the pannel marker...but first time...not bad at all...

Carharts, long underwear...and a large torch set....

Nice....if that was a 7K box I would bet it would be a little more org. Slam one draw shut and wedge a screwdriver between the drawer your shutting and the one above..... scratch the hell out of your new box....yea...Not!!

I was just soldering pipe together today for my air lines...gas really not an issue..FLUX is and I just use a gob on the fitting put the fitting on heat it up rub the solder on...and all of it will flow all the way around your fitting...Good luck with it..

I have sold about 25 of them on ebay....POP guns ( yup that is the name)...for some reason everyone goes crazy for them....I get about $100-150ea out of them....if you check it out that that works for you let me know I will get one for you from my grainger scratch and dent guy..

:thumbup::thumbup::thumbup: You will like the Tormach...I just sold mine to get another bridgeport ( after I sold it to buy the Tormach )...but those are very cool little machines and very easy to use....I kinda went the other way and ordered a new fab table.... Very nice build!! What side of...

YOU **** ASSSSSSSSSSSSS!!!! Great Deal!! I would have bought that in a sec for $500 they are so handy