Search results

finn, I guess 1 less minus you. There always has to be one that jumps in can not be serious.

Thanks for all the info guys. I will try you ideas in the morning. and as for dvblanch's idea I will have to pass. Not my way of doing on a high speed tool like this. I already had a blade once break apart. 30 stiches in my leg later.

So I have used angle grinders for years and never had an issue. Now maybe all this time I have been using it wrong. MI just got the mini DEWALT 4-1/2 corded grinder. I put a cutting disk on and it will not get tight, the disk is to thin. Tried a different brand and same thing. The way I do it...

Thank you, I will check.

Anyone know where to get the craftsman easy read sockets? I looked at LOWES and can not seem to find them. I am looking for 1/4" deep socket with the easy read writing on them. My eyes are getting bad so need bigger writing. Thank you

Is like $230. To rich for me and I do not use them enough to warrant spending that much.

My system is 15psi so I did 12. I always check system pressure before pressurizing any system.

Thank you everyone for all the input. I did what pilotmotor said. I had an extra cap in the shop and turned the compressor way down to 12psi. It worked and founf a pinhole in one of the hoses from rubbing. Now I can take my time if I get a pressure kit. ASTRO is nice but I do not need a $200+...

I bought a coolant pressure tester kit from Amazon a few weeks back. I is pretty nice but it leaked air at the quick disconnect. I returned it and they sent me another, same issue. It has the adapters to fit all my cars. Can anyone recommend a test kit that won't leak? I will not be use much so...

Looking to buy a inspection bora scope. Will not be used much and do not want to spend big bucks on it. Any recommendation? I had bought one off Amazon that plug into my phone but it was junk.

Sensor got wet and has not work since. No lights on it and tried rearming it with no luck.

I will order new ones but have to wait, out of work so money is very tight.

There is 2 terminals for each sensor, Which should I jump out?

I have a old Genie garage door opener on my shop. The safety sensor broke. Is the a way to bypass them? I am the only one That is in there so not worried about that. Do not want to spend the money on a old unit that still works.

I was told I will need a regulator on these solar panels or it will damage the battery by over charging it without it?

Thanks for the info. I will look at them. I want to make sure it has a reverse diode so it will not drain battery at night. Do I need to worry about a over charge issue with these?

I am looking m to get a solar battery maintainer. I have 2 plow trucks that sit most of the time. The batteries are sometimes dead when I go to start the. One is a Jeep and sit in front of my house. I would like one the plugs into the cigarette lighter and can just be left there with out...

Thank you, I have a few pol stain brick from him thgat are used for block. I will try these tip on them first and see what works best.

So I was looking at the Gladiator cabinets for my garage. I like the black with the diamond plate but it is going to be a hard sell to the wife and myself to spend $200-300 a cabinet. Are they worth it, is there a difference between the standard and premium? Is there other brands like them that...

So over the winter my Jeep Wrangler blew a transmission line in a friends driveway right in the 2 year old pave bricks. Cleaned up best I could in the snow but left a nasty stain. I told them I would replace the pavers but they do not want me pulling it up. It is a 4;x5' area. Is there a good...