Search results

Good to hear. Please share the outcome. :thumbup:

What I tell my guys every time a service call comes in on a power unit…”Is the voltage correct?” Of course the answer is always…”Yea, they confirmed the voltage is definitely 220-volts." We swap the power unit then low and behold, the second one too is mysteriously bad. Now, before we ever...

Which roller(s) are you referring to? Each carriage has eight carriage rollers - four located inside the columns (kind of hidden) that are for lateral support (the main rollers), then four mounted outside of the columns that are for fore/aft support. Try SVI.

Other low-ceiling alternative.

Just sharing with the GJ brethren. New client in North CA. A 20-year dream that finally became a reality. Six month project from start to finish. Concrete was recessed (and tiled) along with underground piping for routing of hydraulic lines and pneumatic hose. Client dedicated a cabinet...

The older RJ-45 is not ALI approved. When BendPak opted to get the jacks ALI approved in response to market demands, the result is slightly less arm reach (moment loading) and higher drive-over height (strengthening of upper tube and arms). Why? ALI certification dictates that the bridge jack is...

Thank you for the feedback. Our technical writers are making updates to the manual based off your comments.

16 locations. https://www.quickjack.com/costco.html

Thank all of you for participating. We read through all of the entries, and although a very close race, we're selecting the post written by Army veteran, 1redTA - POST #20. Thanks for sharing your amazing story. You’re a lucky man. My dad was an Air force firefighter (one of many roles during...

85.5" is narrowest spacing inside lower. There is a newer model that is 8" wider available end of year / PL-6SRX.

Thank you all for participating. It’s great to see the GJ community working together for the common goal. Will be heartening to see one of you vets take home the prize. We will be reviewing all and making an announcement in the next day or so. Also, this lift will be covered by the full...

First thing to try. Raise lift until mid-level making sure to park it on the same lock position(s). Then tighten both equalizer cables until each is a little less than guitar string tight. Best to have a load on the lift to make sure as you are tightening the cables it isn't just lifting the...

4" 2500 PSI is just fine for a 7K four post lift. Jeff BendPak

OK already, CLICK HERE and fill out the form. Let us know what you're interested in and we'll write back with the good deal. But time is running out!

Sorry Frank. I still like you. See you in Vegas if you're going to SEMA.

Mohawk, Rotary, Challenger (and of course BendPak) are all worthy contenders. If you choose either, I think you would be pleased with your purchase. I am curious however why Nussbaum would be considered a top-shelf product. Is it the German name, is it the high price? Nussbaum played in the US...

Actually Frank, the reason Rotary Lift and Challenger (both good brands) "have the" USA car dealer and franchise auto repair markets is because they choose to stay in that arena – they have for decades, whereas BendPak caters to general repair shops (all types) and plenty of car dealer business...

This is the new link for the official Group Buy thread. Sorry, only two more weeks to go. Prices going up. https://www.garagejournal.com/forum/showthread.php?t=397598

They would ship out of CA either to an installation firm or your res./bus. For the shortest LCS model you should be able to use a delivery truck with a hydraulic liftgate.

It’s good to see that you take safety seriously. Be very cautious with that lift. Around 1984’ish, while newly employed at BendPak, I was working on a new two post floorplate lift similar in concept as your old Weaver. One cylinder, with a forklift/leaf-type chain routed over a cylinder roller...