Search results

Picked up this 1/2" drive ratchet set today and only markings are stamped Made In USA on all the pieces. The set comes with the ratchet, extension and 21 sockets. Any one have any ideas who made this and any info Thanks for the help Kevin

I picked up a 30 ton bottle jack for my shop press and the ram has some rust on the top section. Looks like someone left it extended during storage. I hit it with the wire wheel on the bench grinder and the surface does have small pits. How important is the surface condition to the operation...

I need to do some front end work on my 04 Durango. I need to replace the inner tie rods. I can get a rebuilt steering rack for less than $200 or try to replace just the tie rods. I can't find any good info on how do to do this. The service manual only shows the rack replacement as an...

This is a Craftsman roller cabinet. The model is 706.650280 Measures 27" wide 18" deep and 40" tall I purchased this new about 25 years ago. I think this is a made in the USA cabinet, but I am not sure. Always been in a home shop. All the drawers have had a liner in them so the bottoms are...

Confused. Getting ready to order the G73 heater but does it stay on all the time? Read the thread about remote themo and understand that the unit should have power so the fan operates correctly, but when I am done in the garage do I turn it off some how? The garage will be almost same temp as...

The Flashlight - Bright as the Sun thread is great for "cordless light" Looking for a great solution for my retractable 120v drop light. I have a CFL in it now and if I work in the driveway it just does not work well in the engine compartment with the sunshine. In the garage it is not much...

I purchased the HF side tool locker and to keep it shut it uses a key lock. So I have to have the key to open and close and also it is spring loaded so i can't keep the key in the door without it falling out. I am looking for a replacement handle and found the following handle on a cabinet we...