Search results

Darn nice looking vise

Need picture of Walker 882 series C jack name plate the few I find are too damaged. If you have the jack with the name plate I could use a good clear picture to make a sticker to put on the jack I did find a good picture of the ram sticker. Thanks for any help Joe

Find an old Walker 882 and rebuild it. Not hard at all here is the one I just did

I am game to try out a new tool

Thanks I rebuilt the ram myself as well

Here it is all done

This

What about the ball bearings in the rear casters are they supposed to be sloppy? They seem sloppy like they both could take one more ball bearing and there is no grease in there as well. I may just leave that alone if its fine cant really see any room for one to fall out. I will start putting...

ok will do

I have removed everything now except for the ram cylinder. Does it need to come off? Cant tell if anything is behind it for a seal or its just metal to metal. I applied heat with no luck. Thanks Joe

Took a bit more off today. Looks like the pipe wrench was used on the ram assembly as well don't think it will matter only the inner counts? also lots of Loctite was used

Thanks

Ok so how do I get the exploded view I have one that is barely readable looks hand drawn. Thanks for the assistance

Yeah I saw the sticky with the socket made for removal just seemed like something was missing from the end is all I have spoke with Hiball he steered me to the seal kit

Looks like my kit will be here tomorrow already so this weekend I will attack it.

I use silicon carbide(very low dust) for everyday paint rust removal then walnut shells for non aggressive paint and tarnish removal on aluminum

Should the end look like the picture or am I missing something? This looks like it has been apart with a pipe wrench before

Hello I have ordered the seal kit for a Walker 882 ram that I am going to repair does anyone have a specific sequence or order to dismantling the ram? Thanks Joe

From 96 to 89

Here it is with a muffler the dbs dropped again and the tone is very tolerable. I am going to put egg crate foam behind it on the wall and use some machine base spring isolators on the feet and that will be that. That is the best way I could figure to mount it. Did not look to good straight up. Joe