Search results

Congratulations! What a great experience and memory for your family.

I have a Beacon Morris BRT-045 heater that will not ignite. I have replaced the gas valve, tried a new ignitor and have tested the pressure switch and will still not ignite. The only other thing I can think of is the control board. Part of the control board is discolored by some resistors...

The project looks great. Very similar to what I would like to do in a few years. Nice roof line, verify similar to out home.

You should send you plans to Air BNB. They are giving away 100k to complete your dream space. https://news.airbnb.com/omgfund/

It is an Argo. Drive it on land or water.

I will have to check it out. I've got 525 sq ft. Do you a large amount of overruns?

I agree with the comments above about the entrance from the garage into the laundry room. Increasing it's size and adding a bathroom would be money well spent. A large mudroom at the entrance is something that I feel always gets overlooked.

You aren't too far from me then. I'm in Pine Springs

That looks good. Love the floor

I have a question regarding vapor barrier in a garage ceiling. Recently moved to a different house and I want to insulate and heat the garage. The ceiling has sheetrock installed directly to the rafters. There is currently no insulation in the attic space or plastic. I'm wondering if I can place...

We had a new house built about 6 years ago by a national home builder. It was about $115 per sq. foot. This was in the Twin Cities area in Minnesota

You can go the other route and not dig any holes at all. http://www.pinfoundations.com/ A lot of people are using these in the area for deck footings. We have a high water table with lots of clay. No heaving in the winter.

It looks good to me. Just keep doing what you are doing and it will probably be fine when it is finished. I know exactly where you are at. You are only about 10 miles away from me. I would like one of those lots with the hangar in the back yard.

Check out Hartje Lumber near La Valle, Wisconsin. I purchased some for my garage from their scratch and dent section. They were very easy to deal with.

I have some upper cabinets. I believe they are Youngstown. I would love to find some more to match.

I used the garage door insulation kits from Lowes and put the foil bubble wrap behind the styrofoam to keep it in place. The stryofoam panels are not as thick as the door. The bubble wrap added more thickness to help keep in place. The only problem I created now is that I get moisture...

Here is the photo of the loft that I built above the doors that I described above. Hopefully it will work out for you. I sure like the extra space. I just need to clean up and get things put away.

I built a loft in my garage. Very similar to the photos you posted. I used the threaded rod 4'-0" o.c. to support the front. I used 2x6 framing at 16" on center and 1/2" osb for the floor. The size is 30' x 6'. There is about 5'-2" clear above. I also built a railing with 1" square tubing and...

Go to Lowe's, Home Depot or Menards and they sell Jamb extension kits. This includeds an extension for the threshold also.

I think you would need a minimum of 24 feet from the garage to make the turn. I drew it with some turning software we have at work. I tried to attach the image so hopefully it shows up. The car shown is a little longer than 16'. Hopefully this helps you out.