Search results

"...Have you tried to bend with it yet?." Yes, I have and I still need to tweak some things. Because of the sharp edges on the flat top V-die, the piece being bent does not "slide" evenly causing the location of the bend to move. I'm going to try and lubricate the V-die to see if that will...

Very nicely done. I enjoy the mix of wood and steel. Britt

Ray Did you used to post on the FFCars.com and Factory Five Racing forums? Britt

I saw the recent posts regarding Swag Off Road press brakes so I thought I would post my experience. I purchased the Swag Off Road 20 ton finger brake in December, 2014. I also purchased the Flat Top adjustable V-die and the arbor press plates. Since I have an Arcan press I had a little bit...

I've been lurking on this forum for about five months now and I thought it was time to introduce myself and start posting. I'm embarking on a new car project that will be extensive with a lot of fabrication. I enjoy fabricating stuff to the degree that I'll look for changes that can be made just...

More testing. I now want to learn how to imbed a URL and hyperlink. I purchased an Arcan press. I also purchased a Swag Offroad 20-ton finger brake.

I think the 640 pixels wide works best.

The previous picture looked good on my iPad but it was from an older set of pictures I had in Photobucket. Trying something new. I adjusted the below photo to 72 pixels per inch, scaled to 640 wide and set the .jpg level to 100% and then uploaded it to Photobucket. I want to see how it looks in...

This is a test. Needing to learn how to post pictures. Let's see how this works. The preview works. Let's post this and then view it on my iPad. :drool:

I don't know the direct answer to your question. You might find this web site helpful. I found it while researching how to raise my garage door tracks to accommodate a lift. I also installed a Liftmaster 8500 wall mount opener. This further cleaned up my ceiling. I hope this helps...