Search results

and ttt

lookie here. offer

recently retired. i can't find everything, as i stored (packed away) a few months ago. a couple more attachments, another dmm, and a non contact volt stick, i can't find. #381, 375, 233. 12B, 65, 52, (3) 27. Attachments (2) 80i400,SV225, PV350, 802K8,

hold my beer.................. i'll be back.

ttt...

press fittings save on labor. not on cost. if a fitting blows apart, and they do, a replacement wont be as easily sourced as a sweat fitting. as is the crimp tool. alot of contractors rent them per job, not outright own them. installing contractor wants to rip out the existing copper WHY...

7 piece set, 3/8 drive, made by Easco. 6 point sockets - 3/8. 7/16, 1/2, 10, 11, 12 mm. reversible 3/8 x 3/8 ratchet head. excellent condition. gold color plated. paypal friend, check. $75 shipped USPS priority.

:hellobye:and r11, r113, r114

your original qwestion - can an attic blower be used as a wall filler? yes, with a lot of screwing around. we blew cellulose into the mt 2x4x14 voids. both home depots and menards, are described as attic blowers. we went to menards, most likely the 11% off. both places the units were very well...

forgot about this thread. retired 6/30/22. and then finally got around to installing. i have NOT worked on it everyday. moved exist water heater about 18'' back. with the shortened run of that flue, the downhill pitch was really noticeable. wound up miter cutting 3'' flue, and mig welded, to...

i use a mapp gas torch to lite charcoal. jah. the striker inside likes to go kaput. and for some reason, an external spark source won't ignite the torch, whether a striker or lit flame

martin, USA manufacturer of strike wrenches, don't make them that little. starts page 27 https://www.martinsprocket.com/docs//catalogs/industrial%20hand%20tools/industrial%20hand%20tool%20catalog/industrial-hand-tools-catalog.pdf

50 years of power tool use, some beat into the ground. never had a problem with brush problems. and, i repair my tools usually the cord or the switch. in the case of metabo grinders, it's the damn pc board

interesting. i'll have to look into that.

nice find! looks like publication may be 1/69. waaaaay different neighborhood now. looks like the shop is now a gas station.

yep, kroil smells great! but, tri flow smells better! and i have another can of some no name spritz really smells good.

working on an olde tired chiller, a couple of 1/2 bolts snapped. basically the head twisted off, leaving a body of about 3/4 sticking out. this flamshooter worked wonders. 3/8 drive, tightens onto the stud, as you ratchet it lefty. similar to a drill chuck, but, lefty pulled the studs right out...

vampire killing tool

in 6 point and 12 point. 8 point where available. swivels where available. standard, semi deep, deep. chrome and impact

friction - or - riser clamp