Search results

I like the Idea of digging out under the left side. If you scrape out just to the center point you can use the center point as fulcrum to adjust angle. This assumes that the porch is flat on the bottom that is a bad assumption. Back in the day concrete was cheap and no telling what lies...

Sounds like a plan. Get ya a industrial dust buster for all those dead beetles.

Many people use gas to light fires, every so often somebody gets to go to the hospital. Wood chop saws were not designed to cut metal. Metal chop saws were. Metal chop saws run close to 1/2 rpm of others. Wood saws don't have a material clamp which is important for cutting metal. If ya...

Engineer pretty much stated the obvious. I wonder if sistering the beams (looks like there is more than 1) on both sides and use structural angle iron tru bolted to lower beam to carry the load off beatled beam. You would probably need a jack-able support wall on both sides and just jack slowly...

I have never seen a deck with timed spindles , that should narrow it down.

Had to put new tires on the bobcat, put jackstands on back and just used bucket to hold up front. After lunch I come out to find glass door laying in bucket in a million pieces. I started looking for the piece of $*** that vandalized my bobcat. After a few hours I realized that the door had...

The primary use is to have a quick way to mount multiple conduits and pipes perpendicular to unistrut. Use two fasteners to hang unistut and hang multiple hangers from unistrut. Much quicker if you are dealing with concrete or hanging pipes off of all thread several feet off of ceiling.

If you don't get along with your neighbor, don't cheat the setback by a foot.

Yep, that's why I actually weighed and figured CG actual with truck in loaded condition. Then there is no need to hyper-extend pads to try to balance F to R weight diff. Stands are good insurance too.

I found the center of gravity of my truck (science) and lined it up with the posts. Then used the frame cradles I made for my lift.

So..... you were just born with this knowledge?

Hey, has anyone seen my box of single hole conduit straps?

Speaking from experience, he will remember this for the rest of his life.

I wonder if you could throw it in a nice hedge fire for a few hours.

Just a thought. If you have connections in the original box behind the pegboard it needs to have access. Perhaps a blank plate and cut pegboard around plate.

Why not make a support from the outermost part from the rack that would support from the floor, halving the load on the wall. If you don't want them sticking out, make them angle back towards the wall meeting the wall at the floor. wall | |leg or wall| /angled leg.

Code writers need to keep their jobs just like politicians. Just don't be accused of a hate code violation. Sent from my iPhone using Tapatalk

Look I get it! You act like getting shocked by 110 is some life altering occurrence. The last time I got "hit" my reaction was Hmmm I must have turned off the wrong breaker. So you are saying that all neutrals should be marked with what hot wire they coincide? I have never seen this done...

Congratulations, sounds like you wasted a lot of money on pipe!

Well all I can say is my 10,000# two post come all beat the hell up and most of the damage was hard to see until it was unwrapped. And it wasn't my fault.