Search results

What are you guys using for the leveling feet? Thread size? Rubber or solid? weight capacity? There are many options & price gets up there when you need 12 or so.

You are correct. Instructions did not show how to set up the locking mechanism. I assume you figured it out just as I did. If you need a detailed photo I can post one up. Rich.

So I have had my MaxJax MX-6 lift up & running now for the past 2 weekends. What a nice addition to the garage. Seriously saves on time & my back. Should have bought one years ago. I've read a lot about chattering & the cat additive but was never concerned. This past weekend I experienced what...

Up & running flawlessly. First lift with the 20 year old test mule. Solid as rock, the lift that is. The car, not so much. :beer:

Thinking about using the epoxy with the pd58 anchors. For those of you that did this how were you able to work fast enough? The stuff starts to gel up in 5 minutes according to the spec sheet. It will harden in the nozzle long before your half way done. If this is the case I may not go this...

If it is ants get some advion ant gel. Stuff is awesome for ants. They eat it like candy. Guaranteed to kill them...

The picture is too blurry I cannot make it out. That may need to be seen under magnification also. Those look pretty small. Looks like there are fragments of the pink insulation also. Do you keep getting sand or sawdust piles? Your also in Ohio I see so they may just be something specific to...

Need a close up of those. Can't really see them. Do you have any standing water nearby? Looks like some kind of flies with wings? Possibly drain moth flies if you have standing water nearby. I used to work for a pest control company. I'd like to see a close up of one of those. Identification is...

So with a sloped/pitched floor, should the holes be drilled plumb or perpendicular to the surface. I know I will be shimming my posts as my floor is pitched. I do not remember if this has been mentioned previously. R-

Thanks. Ordered mine today. Should have it in a week. Looking forward to drilling holes, Not!

I imagine most installs will require the shims. I would think all garages are sloped towards the overhead doors. The shims supplied with the lift, are they plastic or steel? I'm very close to purchasing this lift. My garage floor is level from right to left, but is sloped towards the entry door...

I think I'm ready to pull the trigger on this one. Do you have any better pictures of the locking mechanism, like both sides of the post? Haven't found any of these on the east coast. The ones that advertise selling it near me say it gets shipped from California. So when I finally do order it...