Search results

Guys , need some input and suggestions here . House/garage is on a well and I`m having a problem with limescale/calcium particles clogging the aerators and filters on the water lines . When I clean them out the stuff is hard white particles that sort of looks like white sand . Had it analyzed...

Need some suggestions guys . Just installed the engine and went to put the oil temp sensor in . The engine builder put an aluminum plug in the steel bung/sump ( Canton 8 qt road race sump ) ... said he didn`t tighten it down much. Guess what ? It ain`t moving . Being aluminum , the Allen wrench...

Looking for some suggestions on what to coat the vinyl weather stripping with to keep it from sticking to the garage door . New house and the door was painted about 2 months ago . Seems it hasn`t fully dried yet as the door sticks to the vinyl really hard . I don`t really want to use a spray...

that can be adapted to a Liftmaster chain drive door opener . The new place in the mountains ( vacation place ) has a garage door that has a manually operated lack .... and I can already see a potential problem here . Lock the door from the inside and then come back several weeks later ...

Will be moving into my new mountain place in a few months and am planning on putting Racedeck tiles in the garage . Since I will be doing some reloading there , late last night it occurred to me that there might be an issue with "plastic" tiles and static electricity ( not good if working with...

After fighting the temp sensor install in my intake manifold where there is very limited room for an open end or a box end wrench , I decided I need a "box end , line/flare crowfoot wrench . Did a search on the internet and can`t find such an animal , and before I try to make one ( box end , cut...

Building a vacation house in the mountains and will a 1 1/2 car garage/workshop area . They won`t be pouring the floor for several months yet , so I have some time . I plan to "paint/coat" it ... probably U Coat or something similar . Is there anything I need to tell the builder to do to make...

Guys ... looking for a source where I can get some type of small wire "gauges" that I can use to measure orifices in brass air bleeds , idle feed restrictors etc in my carbs for fine tuning . Sizes will range from .024" to .080" .... also need a source for small drill bits to drill out the...

Been an on and off lurker trying to get ideas on what to do with the disaster that is my garage . Cars are my thing with a restored 63 1/2 427 Galaxie and an ERA 427 SC Cobra replica sharing the garage ..... along with tools , engine hoists , stands , spare shocks/springs/parts/welder etc ( I...