Search results

  1. N

    Ghostshield questions

    I just had my shop floor poured on Monday and Tuesday and was planning to seal it with lithitec 4500 and siloxa tec 8510 from ghostshield. Before spending $1500-2000 I emailed concretesealersupply with a few questions and they responded with the following: "On a power troweled surface, you’re...
  2. N

    House wrap on a pole building

    So I recently finished up building my pole building using RRBuildings YouTube videos as my guide (documented HERE). One thing he does is install house wrap on every building he constructs touting that it's not so much for water intrusion but primarily for wind infiltration. I always wondered how...
  3. N

    12 Hydronic loops in 1 zone

    I am planning the floor portion of the shop I'm building. It will be about 3000 sqft of concrete. I am figuring on twelve 1/2 inch loops but since I haven't come across any 12 port manifolds I'm not sure what the best way to do it is. I'd like to do just 1 zone for simplicity and cost reasons...
  4. N

    R value of garage doors

    I would like input on my upcoming garage door purchase. I am buying 4 garage doors for my 50x63x16 pole building. The sizes will be 10x10, 10x10, 12x12, and 18x10. I have settled on Hass doors. The prices for doors and installation I have received are as follows: 600 series (R 13.5): $6850 700...
  5. N

    50x63x16 Shop Build

    I've always enjoyed reading build threads and finally have the chance to do my own and since my permit has been approved and the grading is to begin this week I figured now was the right time. Before getting too far into it here's a little background information. For as long as I can remember I...
  6. N

    Another 100 amp panel thread

    Hey guys, I'm in the planning stages of my shop build and am now figuring out the electrical. I'm trying to do the research but just get more confused the more I read. I currently have 200 amp service in my house and the run to the sub panel of the proposed shop will be about 250'. I'm not dead...
  7. N

    From little barn to wood shop

    Hey everyone, I have recently purchased a new (to me) house in Wisconsin with a small neglected barn on the property. After some deliberation on what to do with it I decided to make it into a wood shop instead my original plan to use the basement since the basement stairs location isn’t very...
  8. N

    Test post

    This is a test post
Top Bottom