Search results

I have been searching the postings on TIG recommendations and there's a ton of info - but wanted to get a better picture on everyone's take on which way to go between these two welders: Diversion 180 vs. Syncrowave 210. Seems the 210 has many of the ease of use features originally in the...

Well it's been a while since I moved to Oregon, used to have a nice setup in TX (30X52 with metal Z purlin and I-beam loft I fab'd myself) and it took me a while to get going on my shop out here...posting a few pics of it in construction as well as post construction and starting to fill up...

Found the American Industrial CI521E80V compressor while searching the Rapidair site - I'm on the verge of purchasing a Champion VRV5-8 from TP tools but this unit seem comparable and quite a bit cheaper...any experience good or bad? http://www.rapidairproducts.com/americanindustrial.asp Thx!

Have been reading a bunch of posts on the G-floor mats but there's not a ton of info on using these as trailer flooring material. Anyone have experience using it on your car hauler trailer? I'm looking to use it for an 8x24' enclosed car trailer - plan to lay it over the plywood flooring...

Stay away from Ironite! The performance has been poor and the customer service has been even worse! Please see the thread below, read my last entry! http://www.garagejournal.com/forum/showthread.php?t=12503

Ok, the 10K lift is installed in my "Garage Mahal"! Now the interesting part....where's the best place(s) to put the lift pads to safely lift a 1966-77 bronco? It's odd to think but the stock wheelbase is so short you actually have to drive forward of the lifts center, swing the front arms of...

Finally got moving again. Spent a LOT of time prepping the floor for the coating. Lots of pressure washing, acid washing, and pressure washing again. Got all the dirt gone....today we coated the floor. I used Ironite Eurathane Epoxy....you can check it out at this link...