Search results

Im thinking of putting a shower in shop. Has anyone else done it, Open to do's and dont's

Im thinking of running power from shop to a trailer about 100 ft away. Has anyone done this ? Advice

I have a problem wit moistre in shop. Anyone else ? What bave you done to take care of it

Ive just drywalled and insulated 2 walls of my shop. Now Im straightening up.just dont know where to put 4 diff levels of varying lengths.

My shop is lower than my house. But very close. Id like to hookup to septic system, using a pump. Has anyone else had a similar exp? How did you overcome it

Im hanging cabinets in shop that measure 2ft X2ft. The problem is hitting studs. Thinking about putting stringerboards behind them attarched to studs .Than put cabinetson them. Open to ideas

Im getting new counter tops and need to remove the formica one. I would like advice, tips before I tear into it . Pretty sure I can fig it out but still open to tips from someone who has done it . Thank you

Im about to get quarts countertops and backsplash installed. What should I do about new thickness? Should I tear out existing boxes and put winged outletboxes after install

Im wondering if anyone has started with say a plastic toolbox and it cracked and so you repaired it using steel. Than again and again until it is hardly what it started out as but same shape

I have a sink in my shop granted it is only hooked to a Frenchdrain . But I like having it! If I wasnt lower than house I would have installed a toilet for sure. How important is it or do you wish you did?

I have a polebarn ,Id like to puta loft in . Looking for ideas. Its 400sq ft . I just want a small loft on back one half. My plan was to use three existing poles as supports , than using a cross member to go up to for the corner.

I want to put a 3 way switch connecting two lights that are currently independent of the other including power source. These lights are exterior patio dr lights on the same wall. Realizing I would need to cap or delete one power source, how than can I connect via hallway or 3way switch ?

I need ideas on how to make a sturdy vice mount that folds away. My vice is very helpful, but there are times its just in the way too.

Im lookingfor ideas on using receiver hitch to mount a vice and a grinder. Ive done it once before liked it. Has anyone mounted tubing vertically? Wondering pros/ cons pics?:Help:

I thought this would be a fun thread. Ive found probably half my tools. Thank you forgetful people . I drive a mixer so Im on the road alot. One year I logged 147 found tools. Iguess Ive developed an eye for them . It is like a sickness ,I got to pick up lost tools. Its also the exhilaration of...

I intend to run hot and cold waterlines a few feet underground to shop. What should I use .PVC?

I finally pulled the trigger on a small pole building. The material is in front yard. Shop layed out . Coronavirus, and stay at home order has put it on hold. Frustrated ! Im going to have a 10x12 garagedoor,11ftwalls and a 36in .mandoor

I havent seen any threads on this subject. I want to tie into existing septic system or at least stub out for it. My shop will be next to a bathroom wall my only problem is the quarter inch per foot of fall. House is on foundation raising it up a bit. I wouldnt worry except if it isnt well below...

I m thinking of running a 2 inch conduit under slab of shop to get to other side. It would save going all the way around with romex. Good idea or not?

Ive read so much about workbenches in middle of shop . Would it be a good idea to install floor outlets about where I want workbench?