Search results

Anyone help with finding a grease gun coupler with an outside diameter of 1/2 inch? I can not access this zerk on my scissor lift with the 9/16” OD coupler. Are there longer thread zerks available as an alternative to a coupler? Thanks

Slat wall standards I’ve never installed any slat wall plank systems in any of my garages So my experience with their construction material and finishes as well as sizing is limited. Now I’m thinking an area of my current garage this could work well. Question - are all slat walls sizing the...

Garage projects always take time but it’s time to get started New construction home 3 car garage with scissor lift centered on the right side of the main 16ft door. Some conduit and form shots. 3” was probably over kill Forms create a 20” area for the 19” lift pads. 40” spacing between...

Needing some advice on placement or cuts around my flush scissor lift. It’s as though I need some experience from those doing tile Racedeck flooring I want to use is 18” squares Lift foot print is roughly 19/20” platforms with a 40” spacing in between. 80” over all by 68” in length...

Update: Size of BendPak control box - (pic) Wondering if anyone has some rough or exact measurements of Bendpak's low rise or sissor lift control boxes. I'm wondering......conceal in a 30in base cabinet, or if it's too tall, then a section of a utility closet. Or share any ideas you've done...

oil filter http://i132.photobucket.com/albums/q14/kkad0711/IMG_8469.jpg

test pic

Just wondering how much room any of you have set aside for Enclosed compressor rooms / floor heating, I've alotted 5x11 so far, not having heated floors in any previous shop I just wanted to get some ideas about how much room that equipment requires. Thanks. 1/2 of the 40x60

Lurked long enough. Thought I'd join the madness that is. Garages Putting pencil to paper right now on a 40x60 that will be divided in half. One side being the detail/hangout are, the other the Fab area. Main questions : DIMENSIONS how much room should I set aside for an enclosed utility...