Search results

hey guys my pole barn is comping along pretty good. i have a question though. what is the best way to enclose the gable end that will be 14 feet under the roof. i have chicken trusses and I am enclosing 2 bays and leaving one open. what is the best way to seal the top with all the purlins...

about to start framing my wall on a pole building that will hold my sliding door. is the standard header size that holds the tracks a 2x6? i wanted to use something a little bigger like a 2x10 but all the trim peaces that cover the tracks seem setup for a 2x6 to screw to the top and then cover...

https://www.lowes.com/pd/CRAFTSMAN-1000-Series-26-5-in-W-x-32-5-in-H-4-Drawer-Steel-Rolling-Tool-Cabinet-Red/1001098026 Is this craftsman 1000 26 inch bottom any good or is the 2000 or even a harbor freight much better. From looking at the hyper tough at Walmart it appears the exact same and it...

whats the biggest you can make a sliding on piece door? and also Requesting pics of overhead doors on the edge of the building. My door will be on the flat side and as close to the corner post/wall as possible. My opening is 14 ft between poles. What’s the closest I can get the door to the wall...

Requesting pics of overhead doors on the edge of the building. My door will be on the flat side and as close to the corner post/wall as possible. My opening is 14 ft between poles. What’s the closest I can get the door to the wall and pics are greatly appreciated

Hey guys. First post. It told me to say hi so figured I would. About to frame up my pole barn shop. The roof is done and the concrete and about to put up walls. What are the benefits of running 2x6 horizontal Flat on the inside In between the poles vs running the horizontal upright on the...