Search results

Well I don't recall ever greasing the threader and think its about time. Does any know what type of grease to use other Ridgid which is hard to find around here and expensive?

NAPA 700 transmission jack made by Sunnex I think; marked 520-4002 leaks down when loaded. No fluid leaks.Replaced piston seal no change. Removed release valve looked ok, but there was no ball in port, is there supposed to be one that goes before the release stem. Also when leaking down pump...

Recently tried to buy OTC 7249 Stamped "Made in USA" from ToolTopia. They advised they could not guarantee stamped made in USA but that they were made in USA, :wtf: Bull Sxxt. I talked a few days ago with OTC and was advised they were manufacturing the 7249 again in USA and stamping as such...

I sure would like to know what happened to my previous post similar to this subject:mad:

Just got the new lift installed. When I purchased the new lift I was told the frame cradle pads where not available and on back order. That just sucked, so I am going make my own but need some help from you Guys as to dimensions of BendPaks older model or something similar to compare with...

I bought a used NAPA high transmission jack model #520-4002. It has a slow leak down, about a inch in 3 minutes with a 60 lb load. The only visual fluid leak is at the release valve. It does not look like much fluid is coming out but I can not tell how much as it goes under the base into the...

I picked up a used mt2500 and can not get it to communicate with my 94 or 95 Bronco (which have the same configurations) to receive Data (no code) selection . It will run KOEO and KOER and show codes. I have 2 Primary cards, 1 thru 1996, 1 thru 1999 and 2 Fast Tracks, 1 thru 1995, 1 thru 1998...

I just purchased a Rockwell metal lathe 10" x 36 mod. 25-700 that showns almost no wear in the ways and lead screw with rocker tool post, 4 tool holders and 2 face plates. I paid $750 and I think it was a deal. I want to remove the apron to clean it up to remove chips but do not have a...

The pictured jack is listed on craiglist with make offer. Iam interested but owner doesnt know mfg. Any Ideas? Thanks.

Would like to move subject Thread from General Discussions to Tool Discussion but can not find out how to do it. Thanks widetrackman.:dunno:

My brother passed away and left me his tools including this jack which needs rebuilding. I can not find any no.s or name to order a rebuild kit. Thought someone might ID the jack. Looks to me well built and worth rebuilding. Any comments or help appreicated. I have additional pics if needed.

Been lurking for a while. A great informative site. About time I posted .