Search results

Just got this little gem for being a good boy in 2020. Finally got it setup and noticed that it wasn't holding pressure. After some soapy water all over this is what I found. Its not a huge deal, but is there something I can do to get the leak to stop here? I wasn't exactly sure if that is a...

I picked me up a 20 ton press from harbor freight finally. First use is for a transmission rebuild. I quickly found out that I need the base opening wider...it current measures four inches and I need about six to get gears inbetween. I have not been so lucky searching for ideas on widening...

Wanting to do some rear end work on my mustang and possible drop the engin with k member attached vs pulling it from the top. My question is what has anyone done to support these things when the car is on the lift? I was looking at the hydralic lift tables from hf, but was curious what others...

So I am having some problems when trying to guide people where to park in between my lift posts. I wanted to get this, but I want it to display a line instead of a dot. Might anyone have some suggestions how to accomplish this?

I finally pulled the trigger on a lift and went with the atlas pv-9 wide. I just finished installing it and put the jeep and I am a little concerned. The jeep wobbles a little to much for my liking when pushing on the front or back. On top of that, the one cylinder will not stop leaking out...

I am ready to start adding circuits to my new garage, but when I opened up the panel...I see that there is only one open lug for the ground. Can I double up on grounds here? I searched and searched but can't see to find a solid answer...

Construction on my garage and addition is underway, but I am a concerned about the slab. The back of the garage will be attached to house, which the contractors put in a footer 42" below and stacked block on it...the floor joist will sit on top of the block for that room. The garage on the...

Newbie here...I have been lurking for a while trying to get some ideas for my 30x30 attached garage and I am finally pulling the trigger. I am kindof being rushed into it by the wife and contractor, not really a bad thing, but I still have some things that I can't figure out. For starters, I...