Search results

Hello my HVAC friends! I recently installed a Rheem 90+ Furnace above my office in my shed, along with AC (Installed in conventional vertical, NOT horizontal. I have the AC and electric all hooked up (been running it over the summer. Today's chill reminded me that I had to finish hooking up...

Sorry if this has been discussed, I did do some searches, but you guys use 'Husky' in virtually every thread it seems, haha. I really want a Snap-On tool box to replace my Kennedy. I love the Kennedy, but I bought it when I thought I was going to be doing more machining, the drawers are too...

I've been here for a bit now and have gotten a ton of help from members. I thought I should make a thread to chronicle my 'build' this far and try to keep it updated as the building progresses. in '13 my wife and I were finally able to get out of our house of 10 years and upgrade to a newer...

I've been slowly getting this set up. Steel need to run airlines and such. Quite a learning curve in the hardware. The software seems straight forward. I use CAD on a daily basis at my day job so that is a non-issue. I see there are a few others on the board with these, but must are doing...

http://ingramswaterandair.com/rheem-seer-afue-r410a-complete-split-system-p-24689.html I've been getting little to no feedback from Ingrams support, however I would gall in the order to make sure the coil box and coil are horizontal versions, I would also get a 25' lineset. It's been a LONG...

Pretty cool Optec Units. There is another row of 3 right above me as I took the pic, I left out the one on the far left because of the office/bathroom being framed up.

I'm having some trouble figuring out what I need. I've read through some other threads and have learned I will need a disconnect on this equipment. I've always known about disconnects on AC condensers, but am new to it otherwise. From what I read, it seems I will need a disconnect on 50amp...

What will the results be if I span 10' with Unistrut and hange a light in the middle of it? I'm trying to not hang the lights from long cables, to avoid the sway. But I think a 10' span of unistrut might bow.

What is the best place to buy a Rheem or Ruud Horizontal Furnace and AC coil/condenser? My contacts from my days in HVAC land have dried up. Thanks!

I'm hoping some savvy HVAC guys brows this forum. I'm looking for the dampers for my house to create custom zones. I have all 6" curcle runs too my upstairs and I want to finish the basement. The ductwork isn't big enough to simply add all the runs, nor is there enough room to enlarge the...

I have an open truss ceiling in my shed. The wall height is 12', the center is 16'?....maybe? Anyway, I have purchased 15 High Bay LED light units (square ones made by optec). The lighting engineer figured out my layout and I installed all the conduit on the underside of what is the roof, so...

I did a little searching on this and couldn't find anything on equipment. I have a 2400sqft shed that I sprayed foam insulation into. I left the truss's open so every sq in of interior surface (minus the floor) is sealed. I think though I'm going to need to put in an exhaust fan/ make up air...

Hello, Anyone know where to get parts for the Big Maxx line of heaters? Ordering online is fine, I just can't seem to find anything other than the main blower motor. The Inducer motor on my MHU50 is making noise, so I figured I should replace it before it goes out. Thanks!

Hello all, Looks like lots of neat topics here. I registered while back, but haven't posted until now. I will be doing lots of searches. I've been trying to find some info on permanent air lines to run, but searching this site is a bit daunting. As for my shed, it is a detached 40x60 steel...