Search results

My flashing is warping and buckling on some of my garage doors but not all. . Anyone know the problem. . It looks like hell and obviously the seal is comprised for heat ect. . It's 2 years old but went like this in the first year after garage was built and contractor installed. . Thanks

Hey guys.. my floor is About 2 years old and I'm getting little holes in it.. please help.. scattered around garage

I have a 30 year old compressor that I bought and took the heads off to clean up the valves..I had mentioned before that I was getting air leaking out of the crankcase vent after the pump kicked off so I pulled the check valve and I am replacing it as it was rusty..should I replace the rings...

I need a light and for the outside of the front of the shop..anybody try the one from Costco..it's a Honeywell LED..3500 lumens..or what do you recommend ..looking for something energy efficients that will give off good light..wasn't sure about mercury or sodium or what to go with..I have a...

I have a 26 by 28 garage that is attached on 2 sides to my house..the walls are insulated along with the ceiling..it has 2 insulated 10 foot steel doors along with a insulated man door..there are 2 windows which are apparently not thermal..it has a attic hatch and the attic is shared with the...

Just finished wiring and plumbing my new old compressor..started right up..filled the tank and kicked out at 125.. Then it started leaking air out the breather cap on backside of pump..it's a good size v twin style older one that runs at 1750 rpm..valve not seating is my first guess..any help please

So I read the thread about hard wired or plug and I was initially going to hard wire but then After reading I figured why not a plug its another spot to plug my welder for mobility..so I went out and bought the 50 amp welder receptacle and a plug for the compressor..I just picked up the...

This has probably been beaten to death but everything i find on here is for multiple drops..I would like some advice and possibly photos on a install. My compressor sits between the 2 garage door, about 4 feet of spave between. I mounted my hose reel just above..now should i just run a flexible...

I'm sure this question has been asked before but I did a quick search and didn't find what I wanted..I'm buying a larger compressor and looking at the 60 to 80 gallon size..my largest consumption tool I will run is a sandblaster and sandblast cabinet, which their consumption varies a lot so hard...