Search results

Hey, could you take a look at this unistrut install for my Reznor heater. I made an exact template of the top of the Reznor heater and mounting holes out of mdf and matched the allthread to the holes in the template. I only want to see the allthread coming through the drywall. The unistrut is...

I have a IR garage mate air compressor that wont fill all the way. It stops running at around 75 pounds and trips the breaker. If I drain the tank it will run fine until it hits that point. Ive done a search and haven't found a lot of info. I was using it to run a roofing nailer with a 10...

I had a rough inspection on my electrical and he passed the trench part. He told me to put 15 amp tamper proof plugs on my 20 amp out let circuits, which I thought was weird for a shop. Is that okay? seems like I'm missing some capacity if I do that. On the advice of friend who's a master...

I've looked and searched but I couldn't find an answer. I want to dim 6 LED flat panels. Do i just run the wire to the first fixture and that will dim all of them? Or do I need to daisy chain them or run a 18 gauge wire from each one individually to the dimmer switch? Sorry for the newb question.

I'm putting some low profile led lights as a secondary light source in my modern studio build (link) and wanted to ask how I should go about wiring them up to pass a rough electrical inspection. They obviously need drywall to be installed. So do I just leave wires hanging in the place I want...

Planning on putting up a 26X 28 studio workshop in Royal Oak Michigan. . Some initial renders. from the plan.

Friend of mine gave me some oak planks he'd been sitting on for years so I made an Industrial desk out them and a mantle. Here's a vid of the top being made for the desk. It's kinda long and a bit goofy. Below are pics of the mantle.

And my wife broke the toilet.

Built a new table for a customer. I didn't film the whole thing but I made kind of an ad for it. All those years in advertising. Kind of wove a political message in there too, it just seemed to work for a big table.

The wife wanted new planters for her stands and the company that makes them burned down so I had to get resourceful with some horse mat.

I was looking to add some art to my patio so I posted on a local facebook group looking for free bikes for my project and had a few responses. The video is what I did with those free bikes. Total cost $30. These would look good in bright colors as well. I could also see a few of them mounted...

They let us out of work early yesterday because of all the snow so I made a vid. of me clearing it with my 78 Ariens snowblower. Enjoy.

After watching myself on the vid I think I need it more than her. Still need to hang the TV but for the most part it's done. Enjoy.

Hey guys, I've been looking for a drill press for a while and posted an ad on my local craigslist for the type of DP I was looking for. A guy contacted me about his Delta DP220 which is the type I'm looking for. He wants $300 for it which I think is kind of high but am not really sure. Also...